Billion Electric Company BIPAC 3013G User Manual
BiPAC 3013G
54Mbps 802.11g Wireless USB
Adapter
User Manual
FCC Certifications
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to operate this
equipment.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated
with minimum distance 20cm between the radiator & your body.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
IEEE 802.11b or 802.11g operation of this product in the U.S.A. is
firmware-limited to channels 1 through 11.
1
CE Mark Warning
This equipment complies with the requirements relating to electromagnetic
compatibility, EN 55022 Class B for ITE, the essential protection requirement
of Council Directive 89/336/EEC on the approximation of the laws of the
Member States relating to electromagnetic compatibility.
Company has an on-going policy of upgrading its products and it may be
possible that information in this document is not up-to-date. Please check with
your local distributors for the latest information. No part of this document can
be copied or reproduced in any form without written consent from the
company.
Trademarks:
All trade names and trademarks are the properties of their respective
companies.
Copyright © 2006, All Rights Reserved.
2
TABLE OF CONTENTS
OVERVIEW.................................................... 4
U
NPACKING INFORMATION
I
NTRODUCTION TO THE BI
USB A
DAPTER
Key Features .....................................................................................5
....................................................................... 4
....................................................... 4
PAC 3013G 54M
BPS
802.11G W
IRELESS
INSTALLATION GUIDE .................................. 6
S
OFTWARE INSTALLATION
........................................................ 6
MANAGEMENT GUIDE ................................. 11
M
AKING A BASIC NETWORK CONNECTION
Before You Start ..............................................................................11
Ad-Hoc Mode .................................................................................. 11
Infrastructure mode ........................................................................ 13
I
NTRODUCTION TO THE WIRELESS
Starting the Wireless LAN Utility .....................................................15
General............................................................................................16
LAN U
.................................. 11
TILITY
......................... 15
Profile..............................................................................................17
Available Network ...........................................................................18
Advanced.........................................................................................19
Status .............................................................................................. 20
Statistics ......................................................................................... 21
APPENDIX .................................................. 23
RT-S
AP
ET SETUP WIZARD
Connect to a wireless network in infrastructure mode ....................23
Connect to a wireless network in ad hoc mode................................26
Use this adapter as an AP ................................................................29
MODE MANAGEMENT GUIDE
General............................................................................................32
Advanced.........................................................................................33
Statistics ......................................................................................... 33
SoftAP .............................................................................................34
......................................................... 23
................................................ 32
PRODUCT SPECIFICATION .......................... 35
3
Overview
Thank you for purchasing this product. Read this chapter to know
about your BiPAC 3013G 54Mbps 802.11g Wireless USB Adapter.
Unpacking information
Before getting started, please verify that your package includes the following items:
BiPAC 3103G 54Mbps 802.11g Wireless USB Adapter
One Driver / Quick Start Guide / User Manual CD
Introduction to the BiPAC 3013G 54Mbps 802.11g
Wireless USB Adapter
The IEEE 802.11g Wireless USB adapter provides users to launch IEEE 802.11g
wireless network at 54 Mbps in the 2.4GHz frequency, which is also compatible with
IEEE 802.11b wireless devices at 11Mbps. You can configure this adapter with
ad-hoc mode to connect to other 2.4GHz wireless computers or with Infrastructure
mode to connect to a wireless AP or router for accessing to Internet. This adapter
includes a convenient Utility for scanning available networks and saving preferred
networks that users usually connected with. Security encryption can also be
configured by this utility.
4
Key Features
Complies with IEEE 802.11b/g wireless
standard
Complies with Universal Serial Bus Rev.
1.0, 1.1 and 2.0 specifications.
High Speed transfer data rate up to 54
Mbps
Support turbo mode for 72 Mbps data
rate
Support driver for Windows2000, XP
32/64 bit and Vista 32/64 bit
Supports auto-installation and diagnostic
utilities.
Support wireless data encryption with
64/128-bit WEP, WPA (TKIP with IEEE
802.1x) and AES functions.
5
Installation Guide
Software Installation
Note: The following driver installation guide uses Windows XP as the presumed
operation system. The procedures and screens in Windows2000 and Vista are
familiar with Windows XP.
Insert the CD-Rom that came with this product to your CD-Rom drive. The menu
window pops up automatically. Please click the “Wireless-G USB Driver” button of
this product.
Note: If the CD-Rom fails to auto-run, please click on “My Computer” your
CD-Rom Drive then double-click the “Setup” icon to start the this menu.
6
1. The language-selecting window pops up. Please select the language you use
and click OK.
2. The welcome window pops up. Click the “Next” button to proceed.
3. Please wait while installation.
7
4. Click the “Finish” button to complete driver and utility installation.
5. For Windows XP and 2000 users, please insert this USB wireless adapter to your
computer.
6. The “Found New Hardware Wizard“ pops up.
8
7. Select “No, not this time” and click the “Next” button.
8. Select “Install the software automatically” and then click the “Next”
button.
9
9. Click the “Finish” button to complete installation.
10
Loading...