Page 1
BiPAC 2073
HomePlug AV 200 Ethernet Adapter
BiPAC 2074
HomePlug AV 200 Ethernet Bridge with AC
Pass-Through
Quick Start Guide
Page 2
Billion BiPAC 2073 / 2074 Homeplug AV 200 Ethernet Series
- 2 -
Page 3
Billion BiPAC 2073 / 2074 Homeplug AV 200 Ethernet Series
Do not use the
adapter
in high humidity or high temperatures.
Place the
adapter on
a stab
le surface.
Package Contents (BiPAC 2073)
BiPAC 2073 HomePlug AV 200 Ethernet Adapter
Quick Start Guide
CD (containing user manual and QSG)
Ethernet (CAT-5 LAN) cable
Package Contents (BiPAC 2074)
BiPAC 2074 HomePlug AV 200 Ethernet Bridge with AC Pass Through
Quick Start Guide
CD (containing user manual and QSG)
Ethernet (CAT-5 LAN) cable
Do not open or repair the case yourself.
Avoid using this product and all accessories outdoors.
Warning
Only “Homeplug AV” compliant Power Line Communication (PLC)
Attention
adapter for remote access is necessary
- 3 -
Page 4
Billion BiPAC 2073 / 2074 Homeplug AV 200 Ethernet Series
ETH:
PLC:
Ethernet Port
:
POWER
:
*
Lit whe
n power i
s ON
.
SYNC
:
*
Power line sync
Reset Button
:
1.0 DET
:
Hardware Overview
The LEDs and Buttons
* Blinking when detecting
HomePlug 1.0 device.
* Lit when the power line
sync is established.
* Blinking when networking
is active
* Lit when connected to an Ethernet
device.
*
Blinking when data is transmitted
or received via Ethernet port.
The Ethernet Port
* Press the reset button more
than 2 seconds to reset
device to factory default.
* Connect your device (e.g.: computer, router,
hub/switch , IP pone, IPTV set-top-box, gaming
consoles…) to a LAN port, using the included
RJ-45 Ethernet cable.
- 4 -
Page 5
Billion BiPAC 2073 / 2074 Homeplug AV 200 Ethernet Series
AC Power Outlet
:
Above is an example of
a EU plug
-
socket type
and AC power
Please
DO
NOT
remove
or
disassemble the
socket
clip frequently
Clip Socket
:
The Rear Side and Look After Installing with Clip (BiPAC 2073)
* Install the clip into
as this may cause serious damage to your HomePlug AV device!
Warning
The AC Power Outlet (BiPAC 2074)
* Filtered AC Pass-through available for
electrical devices with Input: 100~240V
AC, 50~60Hz, 6Amp (Maximum)
Attention
cable. Both plug-socket and power cable type and input
voltage/frequency may vary for different countries!
- 5 -
Page 6
Billion BiPAC 2073 / 2074 Homeplug AV 200 Ethernet Series
and direction to
and direction to
Clip Installation
Installing the clip with BiPAC 2073
Follow the diagrams
install the clip.
(This is an example of EU clip.
Please check the lock instruction on
your clip. If you got the “Triangle
Lock”, refer to right diagram.)
Follow the diagrams
install the clip.
(This is an example of UK clip.
Please check the lock instruction on
your clip. If you got the “Circle
Lock”, refer to right to diagram.)
- 6 -
Page 7
Billion BiPAC 2073 / 2074 Homeplug AV 200 Ethernet Series
Hardware Installation
1. Power Connection
BiPAC 2073
Plug the Homeplug AV 200 Ethernet Adapter into the wall outlet/socket.
BiPAC 2074
Plug the embedded AC power cable to the wall outlet/socket.
Please note that the plug type may differ according to different countries.
2. LAN Connection
Connect the supplied RJ-45 Ethernet cable to the Ethernet port on HomePlug AV 200
Ethernet bridge/adapter and the other side to the device’s Ethernet interface.
3. AC Pass-Through Connection (BiPAC 2074 only)
To plug IT electrical devices (e.g.: ADSL router, Set-to-box, notebook..) into the built-in AC
pass-through with an embedded low-pass filter to prevent electrical noise from interfering on
your powering network.
- 7 -
Page 8
Billion BiPAC 2073 / 2074 Homeplug AV 200 Ethernet Series
Connection
of
the B
iPAC 207
3
Connection
of
the BiPAC
207
4
Plug in the HomePlug AV adapter Then connect the BiPAC 2073 to a Create a secure network by a
PC, modem, router or a set-top-box simply push off the network sync
button.
Plug in the HomePlug AV bridge Then connect the BiPAC 2074 to a Create a secure network by a
PC, modem, router or a set-top-box simply push off the network sync
button.
Setup Utility
After you complete the hardware installation, insert the CD-ROM to the CD-ROM drive to
perform Setup Utility for network configuration. The Setup Utility will auto-run. Follow the
step-by-step configuration wizard, the utility will guide you complete the basic network
configuration.
- 8 -
Page 9
Billion BiPAC 2073 / 2074 Homeplug AV 200 Ethernet Series
2073/2074 V101EN
Product Application
Product Support and Contact Information
Most problems can be solved by referring to the Troubleshooting section in the User’s Manual.
If you cannot resolve the problem with the Troubleshooting chapter, please contact the dealer
where you purchased this product.
Contact Billion
WORLDWIDE
http://www.billion.com
Billion Product Registration
Billion is committed to before and after sales customer services. You will get the most out of your Billion's products
after registration. Please register online at
www.billion.com/register to receive valuable services and support from
- 9 -
Loading...