Billi 911000RMW, 911000RUB, 911000SMW, 911000SUB Installation Guide

Installation guide
Billi B-1000

Installation
requirements.

IMPORTANT: This Billi appliance is to be installed by a licensed trades person in accordance with
AS/NZS 3500.1 and AS/NZ 3500.2 and in compliance with applicable state regulatory requirements.
For correct operation of this appliance, it is essential to observe the manufacturer’s instructions.

Water Supply

The B-1000 must only be connected to a
cold water supply. A 15mm stop tap (not
supplied) is to be installed in an easily
accessible position within 450mm from the
B-1000 water inlet.

1. Determine Component Location

Determine the location of each of
the components, taking into account
the tube lengths and space available
(see Diagram 1).

2. Plan Dispense Position

Determine the position of dispenser
mounting hole in sinktop or benchtop.
Hole size required is 22mm.

3. Install Components

a) Connect the Pressure Limiting Valve

(with blue mini-tap ) to the mains
water supply.

b) Connect one end of the white hose

provided to the blue mini-tap and connect
the other end of the white hose to the
Filter Module fitting labeled “IN”.

c) Mount the Filter Module in an easily

accessible position, preferably close
to the front of the cupboard to allow
for filter changes.

d) After establishing where the dispenser

can be installed (within the limits of
the hose length from the dispenser to
Filter Module.) punch a 22mm hole for
mounting the dispenser.

e) Mount the dispenser by first passing

the blue hose through the hole and then
fitting the locking bush and lock nut to the
threaded mounting shaft (see Diagram 2).
Tighten the locknut. Reconnect blue hose
to the out fitting.

Commissioning Unit

Turn on the mains tap and then turn
on the blue mini-tap and check for leaks.
If no leaks are detected, rotate the lever
on the dispenser until a good stream of
water is present.
Note: There may be air bubbles in the water
at first as the water filter is dry.

Allow 2-3 minutes of continuous run to
ensure all air bubbles have been flushed
from the system.

Hoses deleted
for clarity

15mm stop tap
(installed by plumber)

22mm hole
required

Diagram 1

1/4 filter water outlet

Locking bush

1/4 filter water inlet

Locking nut

Diagram 2

15mm stop tap

PLV

Diagram 3

For service and support contact Billi on 1800 812 321 or email [e-mail]

Billi Australia Pty Ltd

42 Lucknow Cr

escent, Thomastown

Victoria 3074 Australia

Designed and manufactured in Australia.

As Billi Australia Pty Ltd has a policy of

continual improvement, all details are
Telephone [phone]
Facsimile [phone]

subject to change without notice. All

goods are sold subject to our published

terms and conditions. Billi is a registered

www.billi.com.au

trademark. 0618