Billet Specialties Gas Pedal Assembly - Street Rod - Oval User Manual

Billet Gas Pedal
#199110/199115 & 199130/199135

1/4-20 x 3/4” B.H.C.S.
Install into bottom of

Gas Pedal Mount

x2

Upper Gas
Pedal Arm

Tools Needed:

• 5/32” Allen Wrench

• 17/64” Drill Bit

• Center Punch

• Loc-Tite® Thread Locker

1. Remove carpet and/or insulation from floorboard/firewall.

2. Position gas pedal assembly on floorboard/firewall - keep in mind pedal
travel, width of foot, & position of brake pedal.

3. Place paper template between gas pedal and floorboard/firewall and tape
template into position.

4. Center-punch (metal) or drill a guide hole (fiberglass) through
floorboard/firewall. Finish by drilling with the 17/64” drill bit.

5. Replace carpet and/or insulation.

6. Install pedal base by applying Loc-Tite® to the two provided 1/4-20 x 3/4”
button head cap screws and threading them through the floorboard/firewall
into the gas pedal mount. A fender washer (not included) may be used for
more support.

7. Position pedal arms for correct placement by removing outside arm and
indexing on splined bushing.

Other Adjustments Include:

• Pedal base can be switched from left to right.

• Gas pedal has two axle pivot options to adjust pedal up and down on arm.

• Lower gas pedal arm can be flipped for added floor clearance.

Gas Pedal

Mount

Gas Pedal

Delrin

Bushing

Splined
Bushing

Lower Gas
Pedal Arm

Shim

Washers

Axle Pivot

E-Clips

Delrin

Bushing

Pedal Mount

Template

Aluminum

Washer

1/4 -20 x 1/2”

Use 17/64” Drill Bit

1.5” Center To Center

F.H.C.S.

IMPORTANT

• Attach throttle cable clevis (not included) to upper pedal arm.

• Check throttle operation before starting vehicle. Gas pedal operation should
be smooth and not bind in any way.

Billet Specialties, Inc. 500 Shawmut Avenue La Grange, Illinois 60526 PH 800.245.5382 Fax [phone] www.billetspecialties.com

Torsion Spring

JAN 10