Page 1
P/N 77930/BLK77930 Power Steering Reservoir
Tools Needed;
1” open end wrench or adjustable wrench
1/2” open end wrench
Loc-Tite Blue Threadlocker
Remove the upper pressure nipple and set aside.
For kits with the RP1300 ow control valve installed,
Remove the RP1300, plunger and spring. Set aside.
REMOVE
INSTALL
Starting at the top, install o-ring as shown
by pressing o-ring straight down directly
into groove.
Remove the threaded supply nipple,
o-ring and washer.
Select the correct size threaded supply
nut. Install with o-ring and washer.
Tighten rmly.
1” deep socket
7/8” deep socket
5/16 allen bolt supplied with Tru Trac or v Trac kit
1/4” allen wrench
9/64” allen wrench
This kit ts the following applications;
-Small Block Chevrolet Tru Trac and V-Trac
-Big Block Chevrolet Tru Trac and V-Trac
Carefully place reservoir onto pump, thread the 5/16”
bolt through the reservoir and pump. Install the 5/16”
installation nut and nger tighten.
Thread the hex bolt with o-ring installed through
reservoir and into adapter tting on pump.
Tighten installation nut at this point.
Finish by rmly tightening hex bolt locking the
reservoir into place.
Place the reservoir back cover onto the reservoir.
O-ring should seat into groove without any
extra length hanging out.
Re-install o-ring if there is any additional
slack.
At this time remove the 5/16” installation nut
and discard. Set the 5/16” allen bolt aside for
later use.
Install the -6 AN nipple tting with o-ring into
the back cover and tighten rmly.
Apply Blue Loc-Tite to the threads of the
ten 8-32 cap screws and install through
the cover and into reservoir.
Tighten rmly.
Re-install the upper pressure nipple at this time.
Tighten rmly.
For pumps that have a RP1300 ow control
valve installed, install spring rst followed by
the plunger - screen side down before the
RP1300.
Install pump and reservoir onto the
Tru Trac or V Trac system bracket with
the 5/16”X3” allen bolts and loc washers.
Install power steering lines, ll system with
uid and bleed.
500 Shawmut Avenue • La Grange, Illinois 60526 • Tech Line 708/588-0505 • Fax 708/588-7181
Rev. 11/12
Loading...