Biamp VOIP EQUIPMENT CHECKLIST User Manual

w

Biamp Systems VoIP-2 Card Advanced Network Settings

This document is intended to assist A/V integrators and IT managers in incorporating the Biamp VoIP-2 interface for the
AudiaFLEX into enterprise VoIP systems. The VoIP-2 card requires the use of a SIP connection with any VoIP system.
Enabling a SIP connection may require the purchase of a third party license and/or additional software from the VoIP system
manufacturer. Manual software configuration of the VoIP-2 card is necessary for proper operation.

To properly configure the VoIP-2 card, the following information should be known:

Basic Network Settings:

1. Does the VoIP system currently installed in the facility carry information over a VLAN? ______(Optional)
If Yes:

a. What is the VLAN ID? ___________________________________

2. Ethernet Settings:

3. Will the VoIP card be obtaining an address from a DHCP server? ______

If No provide the following Network Info:

a. IP Address:__________________________________________
b. Subnet Mask:________________________________________
c. Default Gateway:_____________________________________
d. DNS Primary Server:__________________________________
e. DNS Secondary Server:________________________________
f. What is the Domain? __________________________________

VoIP Protocol Settings:

Line 1: Line 2 :

Subscriber Number

Proxy Username:

Proxy Password:

Registration Expiration Time

(Default 3600 sec):

Proxy Discovery (Default Static):

Proxy Address:

Proxy Port (Default 5060):

Outbound Proxy Address:

Outbound Proxy Port:

BIAMP SYSTEMS TECHNICAL SUPPORT GROUP

w

QoS Settings (Optional)

1. Does this VoIP system utilize QoS settings? __________________

If yes specify settings below (Note that Layer 2 Priority is only valid when VLAN has been enabled):

BIAMP SYSTEMS TECHNICAL SUPPORT GROUP