Ceiling Loudspeaker Accessories
Safety Cable (SPA-SCC100)
Installation Guide
Attach the cable clip to the seismic safety tab or other applicable mounting hole
with the included bolt and nut. Follow warning below.
Safety Cable with Clip
Shown connecting to the
input cover on the DC220T
Safety Cable
with Clip
Nut
Nut
Nut
Screw
Safety Cable
with Clip
Screw
Screw
Shown connecting to the side
flange holes on the DC220T
Shown connecting to the
input cover on the CM10TB
IMPORTANT: Attach the cable to
a secondary structural point
directly above the seismic safety
tab to minimize impact force and swing in
the event of a ceiling failure.
CONTENTS
Cable:
• 4.5m (14.7’) long 1.2mm galvanized steel cable with attached zinc-plated
steel tab
• M6 Screw & Nut
Quantity per kit: Sold in 10-pack
SPECIFICATIONS
Cable:
• 4.5m (14.7’) long 1.2mm 7x7 strand galvanized steel cable with attached
1.5mm thick zinc-plated steel tab. WLL: 50 lbs at 5:1 rating
A: 9300 Gemini Drive, Beaverton, OR 97008 W: www.biamp.com
CAUTION: Installation of Biamp
loudspeakers should only be performed
by trained and qualied personnel. It is
strongly recommended that a licensed and
certied professional structural engineer
approve the mounting. Severe injury and/or
loss of life may occur if this product is
improperly installed.
585.0307 30JUN2023
Loading...