Page 1
A: 9300 S.W. Gemini Drive Beaverton, OR 97008 USA W: www.biamp.com
RMX 100 Rack Shelf
Installation Guide
RMX 100
Representative congurations
RMX 100 with TesiraFORTÉ X and Devio SCX RMX 100 with TesiraFORTÉ X and TesiraCONNECT
COMPATIBLE DEVICES
RMX 100 Rev. A
• TesiraFORTÉ X
• Devio SCX
• TesiraCONNECT
RMX 100 Rev. B
• TesiraFORTÉ X
• Devio SCX
• TesiraCONNECT
• Impera Tango
• PM4100
• AMP-225H
CONTENTS
Hardware, etc
Qty Size / Type Use
8 M3 x 10 Phillips Screw - device attachment
8 M3 Flat Washer - device attachment
8 M3 Lock Washer - device attachment
4 #10-32 x .75" Rack Screw - rack attachment
4 #12-24 x .75" Rack Screw - rack attachment
4 M6 x .75" Rack Screw - rack attachment
25 Cable ties Cable organization
Rack Shelf
Page 2
INSTALLATION
Congurations
One or two devices can be mounted
to the rack shelf. See at right for
applicable configurations. Mount the
devices to the shelf before installing it
in the rack.
Do NOT place a TesiraCONNECT to
the left of either a TesiraFORTÉ X or
Devio SCX.
Ambient Operating Temperature:
32-104° F (0–40° C)
TesiraFORTÉ X
Devio SCX
TesiraFORTÉ X
Devio SCX
TersiraCONNECT TersiraCONNECT
Before assembly
If the device comes attached to a
backplate, remove the backplate.
1. Review the attachment holes for
each type of device.
2. Place the devices upside down
on a protected surface and
remove the rubber feet on the
bottom of each device.
TesiraFORTÉ X
Devio SCX
1
2
TersiraCONNECT TersiraCONNECT
TesiraCONNECTTesiraFORTÉ X
Devio SCX
TesiraFORTÉ X
Devio SCX
Impera Tango
page 2 Installation and Operation Guide RMX 100
Page 3
A: 9300 S.W. Gemini Drive Beaverton, OR 97008 USA W: www.biamp.com
Installation (continued)
3. Place the shelf on top, align the appropriate
hole pattern and screw the rack shelf to the
device using lock washers and at washers
with the M3 screws.
4. Install the rack shelf (hardware provided),
and make connections to the devices per
their installation guide.
3
4
5. Use the cable ties to manage the cables
coming from the devices.
Cables can also be routed along the back
of the shelf by using the holes along the
edge of the shelf (see example below).
CONTACT US
Email: support@biamp.com
Web: support.biamp.com
Warranty: biamp.com/legal/warranty-information
Safety & Compliance: biamp.com/compliance
5
Organize and route cables with
cable ties secured to the shelf
10APR2024
Loading...