Biamp BPAK Installation Guide

Desono BPAK

Installation Guide

C-IC6 or C-IC6LP with Tesira unit

secured with backpack clips and

PRODUCT DESCRIPTION

The Desono BPAK Backpack Kit allows a Tesira AMP-450BP, AMP-450P,
TCM-X or TCM-XA to be attached to the top of a Desono C-IC6 or C-IC6LP
back can.

Kit Contents

conduit cover

(shown with an AMP-450BP)

Cover

Clips and M3 screws

(2 each)

Tesira CAT5 Jumper

cable (not shown)

A: 9300 Gemini Drive, Beaverton, OR 97008 W: biamp.com

C-IC6

Tesira Unit

(AMP-450BP shown)

C-IC6LP

INSTALLATION

1. Attach clips. Installation method is the same for C-IC6LP.

M3 Flat Head Screw

Backpack Clip

2. Fully slide unit into clips

Use this hole for seismic
wire attachment or to
further prevent movement
on the back can

3. A cover is provided for conduit usage or strain relief. Punch out the

cut-out, attach conduit tting or cable clamp and feed wiring through

the opening. Connect wiring per the device instructions. Insert cover
tabs into the slots on the Tesira unit and secure the cover with the
thumbscrew.

A: 9300 Gemini Drive, Beaverton, OR 97008 W: biamp.com

585.0111 25MAY2023