Bh fitness YV30 User Manual

BH FITNESS YV-30 VIBRO-BOOST

OWNER’S MANUAL

BH FITNESS

20155 Ellipse

Foothill Ranch, CA 92610

Phone: [phone]

Fax: [phone]

Email: [e-mail]

BH Fitness • 20155 Ellipse • Foothill Ranch • CA • 92610

www.bhnorthamerica.com • Phone [phone] • Fax [phone]

YV 30 VIBRO-BOOST

INTRODUCTION

Thank you for purchasing our product. While we do our best to ensure the quality of all our

products, occasional errors or omissions may occur. If you notice a defect or missing parts,

contact the distributor of the product. Read through the whole manual before using this machine.

BH FITNESS

20155 Ellipse

Foothill Ranch, CA 92610

Phone: [phone]

Fax: [phone]

Email: [e-mail]

BEFORE YOU BEGIN

It is very important to become familiar with the USER PRECAUTIONS AND SAFETY INSTRUCTIONS

for this product.

BH Fitness • 20155 Ellipse • Foothill Ranch • CA • 92610

www.bhnorthamerica.com • Phone [phone] • Fax [phone]

1

SECTION PAGE

1. IMPORTANT SAFETY INSTRUCTIONS ..................................................... ..3

2. ASSEMBLY INSTRUCTIONS ...................................................................... . 5

3. CONSOLE OPERATIONS ........................................................................... ..8

4. PROGRAM SETTINGS ............................................................................... 11

5. SUGGESTED EXERSICES ..........................................................………....12

YV 30 VIBRO-BOOST

TABLE OF CONTENTS

6. TECHNICAL SPECIFICATIONS................................................................. 20

7. WARRANTY............................................................................................... 22

BH Fitness • 20155 Ellipse • Foothill Ranch • CA • 92610

www.bhnorthamerica.com • Phone [phone] • Fax [phone]

2

YV 30 VIBRO-BOOST

SECTION 1

IMPORTANT SAFETY INSTRUCTIONS

Read all instructions before using the Vibro-boost.

Notice: Before using this or any other exercise equipment consult your family physician or
health care professional to develop a well planned exercise program to fit your health needs. If
you encounter any pain or breathing discomfort while working out, STOP!, and consult a physician
before continuing.

WARNING!

1. Keep children away from machine while in use.

2. Product should not be used by minors without adult supervision.

3. Maximum user weight for this machine is 440 lbs.

4. Keep a minimum clearance of 18” on each side and 24” at the rear of the Vibro-boost for safety.

5. The Vibro-boost should never be left unattended while in operation.

SHOULD NOT BE USED WITH THE FOLLOWING CONDITIONS:

1. Retinal related visual disorders.

2. Serious vascular diseases and cardiovascular problems in general.

3. Pregnancy

4. Serious types of hernia.

5. Hip and knee prostheses (at high vibration levels).

6. Epilepsy.

7. Use of plates, pins and artificial limbs in general or any other internally fitted electric device.

8. Tumors and metastatic disease.

9. Being particularly tired, unwell or overly stressed.

10. Inflammation caused by injuries of an electro-muscular nature.

11. Do not use after surgery (for at least 2 months), post-traumatic situations or transient generic

illnesses such as headache, backache, etc. ... until the symptoms disappear.

12. Vocal cord disorders.

13. Use of contraceptive coils (IUD)

14. Psychological intolerance to vibratory stimulation.

BH Fitness • 20155 Ellipse • Foothill Ranch • CA • 92610

www.bhnorthamerica.com • Phone [phone] • Fax [phone]

3

YV 30 VIBRO-BOOST

SAVE THESE INSTRUCTIONS

IMPORTANT SAFETY INSTRUCTIONS CONTINUED

POWER SAFETY INSTRUCTIONS

This product must have an earth grounded outlet. In the event that the appliance malfunctions the

ground earth connection will redirect the electrical current away from the machine and reduce the

risk of an electrical shock. The plug must only be used with an appropriate wall socket, installed

correctly and connected to earth, in accordance with local regulations.

DANGER! If the equipment is not grounded correctly then there is a risk of electrical shock. If in

doubt, get an electrician to check that the earth ground

connection is correct. Do not modify the plug supplied with

the equipment, if it does not fit the wall socket then get an

electrician to install an electrical socket that does. This

product must only be used on a 120 volts AC circuit, with

an earthed grounded receptacle similar to that shown in

Fig. A. Do not use an adaptor with this appliance.

Always observe the following recommendations when using electrical equipment:

1. Do not use any type of adapter or remove the ground prong.

2. To reduce the risk of electrical shock, always unplug the unit immediately after use and before

proceeding to clean it.

3. Only plug the machine into suitably earth grounded wall sockets, as shown in Fig. A.

4. Never leave the unit unattended when it is plugged in. Unplug it after use.

5. Do not allow children or the disabled to use the equipment without the strict supervision of an

adult guardian.

6. Do not use the machine if the power cord becomes damaged or worn. Keep the power cord away

from hot surfaces.

7. Do not use the machine outdoors.

8. To unplug the machine, first put the switch to the “0” position and then unplug it from the wall

socket.

BH Fitness • 20155 Ellipse • Foothill Ranch • CA • 92610

www.bhnorthamerica.com • Phone [phone] • Fax [phone]

4

r

YV 30 VIBRO-BOOST

SECTION 2

ASSEMBLY INSTRUCTIONS

Handle Ba

Console

Foot pad

Column

Remote Console

Power Line

Floor Mat

Non-Slip Mat

Plate

Under pan

Cushion

5

BH Fitness • 20155 Ellipse • Foothill Ranch • CA • 92610

www.bhnorthamerica.com • Phone [phone] • Fax [phone]

YV 30 VIBRO-BOOST

BH Fitness • 20155 Ellipse • Foothill Ranch • CA • 92610

www.bhnorthamerica.com • Phone [phone] • Fax [phone]

6

Continued Assembly Steps

Step 1

Put the Base on the Floor mat, and then put the left

and right handle bar belt on the base according to

the figure #1.

Fig. #1

YV 30 VIBRO-BOOST

Step 2

Take out the column from the carton; connect the electrical wire and control wire with base

separately (as small figure #2 shows). Put the wire into the column. Then install the column on the

plate, pay attention that the column not press the wires.

Attach the column to the plate with the four M10 Flat washers,

four M10 spring washers and four M10X50 Allen bolts. The

transportation wheel bracket is assembled to the front holes.

Then tighten all the bolts.

Fig. #2

Fig. #3

BH Fitness • 20155 Ellipse • Foothill Ranch • CA • 92610

www.bhnorthamerica.com • Phone [phone] • Fax [phone]

7