Bettis Programming: TEC2 Configuration file convert from TEC2000 using DCMlink | EIM Manuals & Guides

Configuration Instructions

ACT-MAN-01-04-EN Rev. A

September 2018

TEC2 Configuration file convert
from TEC2000 (Model 500 Discontinued)

Using DCMlink

TM

Configuration Instructions

ACT-MAN-01-04-EN Rev. B

Table of Contents

Section 1: Document Purpose

1.1 Export TEC2000 conguration (Method: TEClink) .......................................... 1

1.2 Export TEC2000 conguration (Method: DCMlinkTM) ..................................... 3

1.3 Import conguration to TEC2 unit (Method: DCMlinkTM) ............................... 8

Table of Contents

September 2018

Table of Contents

3

Section 1: Document Purpose

September 2018

Configuration Instructions

ACT-MAN-01-04-EN Rev. B

Section 1: Document Purpose

This document is to show TEC user (1) how to export the conguration le from TEC2000
before perform the “TEC2 covert” which is changing electronics device inside TEC2000
unit into TEC2 electronics. (2) how to import TEC2000 conguration les into TEC2
electronics. There are two tools can be used to export the conguration from TEC2000
electronics actuator. First one is TEClink and second one is DCMlinkTM. Since TEClink is no
longer support TEC2, DCMlinkTM becomes only available tools to access network to the
conguration for conguration import process.Export TEC2000 conguration (Method:
TEClink)

1.1 Export TEC2000 configuration (Method: TEClink)

1. Connect unit with RS485 Modbus on STC21/STC23 (RDM) or STC39 to STC44 with
Modbus network.

2. TEClink export conguration from unit. (Using TEClink to export conguration le)

a) Set the comport and speed correct till the “Green” communication light

shows at the button status bar which means the communication between
TEClink and Unit has built up successfully.

3. Click Recv and wait 10 second till the button color comes back.

1

Document Purpose

Configuration Instructions

ACT-MAN-01-04-EN Rev. B

4. Click Save conguration le (.TEC) le at desire location

5. Save TEC2000 conguration le as unit serial number. (as example is 135614B01.

6. To make sure the TEC conguration export correctly, click “User” to read the

7. Open the TEC conguration le from the location you saved.

Section 1: Document Purpose

September 2018

(Not avaliable-it’s reading in process) (avaliable-it’s nish reading process)

TEC)

current parameter from the unit.

8. If user does not see any column is blue after open the le, the conguration is
export correctly.

Document Purpose

2

Section 1: Document Purpose

September 2018

1.2 Export TEC2000 configuration
(Method: DCMlinkTM)

1. Using DCMlinkTM to perform the conguration export, it requires the DCMlinkTM

rev is greater than 1.2 and licensed. To perform export / import process,

DCMlinkTM application requires to grand Emerson license.

(Please consult Emerson Sales Team for more information).

Configuration Instructions

ACT-MAN-01-04-EN Rev. B

2. Build up communication channel.

a) Click tool bar “DCMlinkTM Setup”

b) Click “Preference”

3

Document Purpose