Bettis Programming: TEC2 CCM Programming Using H-JTAG Software and H-JTAG Download Probe Part 1 | EIM Manuals & Guides
Programming Instructions
TEC2-HJTAG-1001 Rev. 1
TEC2 CCM Programming Instructions
Using H-JTAG Software and H-JTAG Download Probe
September 2015
Programming Instructions
TEC2-HJTAG-1001 Rev. 1
Table of Contents
Section 1: TEC2 CCM Programming Instructions
1.1 Using H-JTAG Software and H-JTAG Download Probe..................................... 4
Appendix
Table of Contents
September 2015
Table of Contents
3
Section 1: TEC2 CCM Programming Instructions
September 2015
Programming Instructions
TEC2-HJTAG-1001 Rev. 1
Section 1: TEC2 CCM Programming Instructions
1.1 Using H-JTAG Software and H-JTAG Download Probe
Figure 1 Bare Board Setup
Figure 2 CCM in LDM Housing Setup
NOTE:
Hjtag Probe has been modified. Software is available at http://www.hjtag.com/en/index.asp.
1. Connect the H-JTAG probe box and USB cable to the computer.
4
TEC2 CCM Programming Instructions
Programming Instructions
TEC2-HJTAG-1001 Rev. 1
Figure 3 USB Cable Connected to Computer
Section 1: TEC2 CCM Programming Instructions
September 2015
2. Connect the H-JTAG probe box to the USB cable.
Figure 4 USB LED should light when USB Cable is connected to PC
and Probe. The TGT LED should light when the Ribbon cable is
connected between Board and H-JTAG Probe. ACT LED should light
when data is being transferred.
3. Connect the ribbon cable to the P10 JTAG connector on the CCM board.
TEC2 CCM Programming Instructions
5
Section 1: TEC2 CCM Programming Instructions
September 2015
Figure 5 CCM Installed in LDM Setup
Programming Instructions
TEC2-HJTAG-1001 Rev. 1
Figure 6 Ribbon Cable on CCM Bare Board Setup – JTAG Ribbon on CCM
P10 Connector
4. On computer, run the H-JTAG software by doubling clicking the H-JTAG Icon.
6
TEC2 CCM Programming Instructions
Programming Instructions
TEC2-HJTAG-1001 Rev. 1
Figure 7 Windows Desktop H-JTAG Icon
Section 1: TEC2 CCM Programming Instructions
September 2015
5. H-JTAG Server should start running.
Figure 8
TEC2 CCM Programming Instructions
7
Loading...