Betco 2370400, 2374700 User Manual
Betco Symplicity Sanibet Multi-Range
Not available.
Liquid.
Chemtrec (800) 424-9300 24 hour
SAFETY DATA SHEET
GHS product identifier
Other means of
identification
Product type
Emergency telephone
number (with hours of
operation)
Section 1. Identification
:
:
:
:
Supplier's details
:
Betco Corporation
400 Van Camp Road
Bowling Green, Ohio 43402
www.betco.com
888-462-3826
Betco Symplicity Sanibet Multi-Range
Relevant identified uses of the substance or mixture and uses advised against
Sanitizer
Identified uses
For Industrial and Institutional Use Only
-
Uses advised against
Reason
Product code
:
237
EPA Details
:
EPA Statement:
This chemical is a product registered by the United States Environmental Protection
Agency and is subject to certain labeling requirements under federal law. These
requirements differ from the classification criteria and hazard information required for
safety data sheets (SDS), and for workplace labels of non-EPA registered chemicals.
Below is the signal word as required on the label:
EPA Establishment Number
:
4170
EPA Registration Number
:
6836-266
EPA Signal Word
:
Danger
Section 2. Hazards identification
ACUTE TOXICITY (oral) - Category 4
SKIN CORROSION - Category 1
SERIOUS EYE DAMAGE - Category 1
Classification of the
substance or mixture
:
Signal word
:
Danger
Hazard statements
:
Harmful if swallowed.
Causes severe skin burns and eye damage.
Hazard pictograms
:
Precautionary statements
GHS label elements
OSHA/HCS status
:
This material is considered hazardous by the OSHA Hazard Communication Standard
(29 CFR 1910.1200).
Date of issue/Date of revision
:
4/3/2020
Date of previous issue
:
4/2/2020
Version
:
1.11
1/14
Betco Symplicity Sanibet Multi-Range
Section 2. Hazards identification
Prevention
:
Wear protective gloves. Wear eye or face protection: Recommended: splash goggles.
Wear protective clothing: Recommended: Chemical resistant gloves. Do not eat, drink
or smoke when using this product. Wash hands thoroughly after handling.
Response
:
IF INHALED: Remove person to fresh air and keep comfortable for breathing.
Immediately call a POISON CENTER or physician. IF SWALLOWED: Immediately call
a POISON CENTER or physician. Rinse mouth. Do NOT induce vomiting. IF ON
SKIN (or hair): Take off immediately all contaminated clothing. Rinse skin with water or
shower. Wash contaminated clothing before reuse. Immediately call a POISON
CENTER or physician. IF IN EYES: Rinse cautiously with water for several minutes.
Remove contact lenses, if present and easy to do. Continue rinsing. Immediately call a
POISON CENTER or physician.
Storage
:
Store locked up.
Disposal
:
Dispose of contents and container in accordance with all local, regional, national and
international regulations.
Hazards not otherwise
classified
:
None known.
Section 3. Composition/information on ingredients
Quaternary ammonium compounds, benzyl-C12-16-alkyldimethyl, chlorides
≤5
68424-85-1
decyldimethyloctylammonium chloride
≤5
32426-11-2
didecyldimethylammonium chloride
≤3
7173-51-5
ethanol
≤3
64-17-5
dimethyldioctylammonium chloride
≤3
5538-94-3
Ingredient name
CAS number
%
There are no additional ingredients present which, within the current knowledge of the supplier and in the
concentrations applicable, are classified as hazardous to health or the environment and hence require reporting
in this section.
Other means of
identification
:
Not available.
Substance/mixture
:
Occupational exposure limits, if available, are listed in Section 8.
Mixture
Any concentration shown as a range is to protect confidentiality or is due to batch variation.
Get medical attention immediately. Call a poison center or physician. Immediately flush
eyes with plenty of water, occasionally lifting the upper and lower eyelids. Check for and
remove any contact lenses. Continue to rinse for at least 10 minutes. Chemical burns
must be treated promptly by a physician.
Get medical attention immediately. Call a poison center or physician. Flush
contaminated skin with plenty of water. Remove contaminated clothing and shoes.
Wash contaminated clothing thoroughly with water before removing it, or wear gloves.
Continue to rinse for at least 10 minutes. Chemical burns must be treated promptly by a
physician. Wash clothing before reuse. Clean shoes thoroughly before reuse.
Get medical attention immediately. Call a poison center or physician. Remove victim to
fresh air and keep at rest in a position comfortable for breathing. If it is suspected that
fumes are still present, the rescuer should wear an appropriate mask or self-contained
breathing apparatus. If not breathing, if breathing is irregular or if respiratory arrest
occurs, provide artificial respiration or oxygen by trained personnel. It may be
dangerous to the person providing aid to give mouth-to-mouth resuscitation. If
unconscious, place in recovery position and get medical attention immediately. Maintain
an open airway. Loosen tight clothing such as a collar, tie, belt or waistband. In case of
inhalation of decomposition products in a fire, symptoms may be delayed. The exposed
person may need to be kept under medical surveillance for 48 hours.
Section 4. First aid measures
Eye contact
Skin contact
Inhalation
:
:
:
Description of necessary first aid measures
Date of issue/Date of revision
:
4/3/2020
Date of previous issue
:
4/2/2020
Version
:
1.11
2/14
Betco Symplicity Sanibet Multi-Range
Section 4. First aid measures
Get medical attention immediately. Call a poison center or physician. Wash out mouth
with water. Remove dentures if any. Remove victim to fresh air and keep at rest in a
position comfortable for breathing. If material has been swallowed and the exposed
person is conscious, give small quantities of water to drink. Stop if the exposed person
feels sick as vomiting may be dangerous. Do not induce vomiting unless directed to do
so by medical personnel. If vomiting occurs, the head should be kept low so that vomit
does not enter the lungs. Chemical burns must be treated promptly by a physician.
Never give anything by mouth to an unconscious person. If unconscious, place in
recovery position and get medical attention immediately. Maintain an open airway.
Loosen tight clothing such as a collar, tie, belt or waistband.
Ingestion
:
Protection of first-aiders
:
No action shall be taken involving any personal risk or without suitable training. If it is
suspected that fumes are still present, the rescuer should wear an appropriate mask or
self-contained breathing apparatus. It may be dangerous to the person providing aid to
give mouth-to-mouth resuscitation. Wash contaminated clothing thoroughly with water
before removing it, or wear gloves.
Notes to physician
:
In case of inhalation of decomposition products in a fire, symptoms may be delayed.
The exposed person may need to be kept under medical surveillance for 48 hours.
Specific treatments
:
No specific treatment.
Most important symptoms/effects, acute and delayed
Inhalation
:
No known significant effects or critical hazards.
Harmful if swallowed.
:
Ingestion
Skin contact
:
Causes severe burns.
Causes serious eye damage.
:
Eye contact
Over-exposure signs/symptoms
Skin contact
Ingestion
Inhalation
No specific data.
Adverse symptoms may include the following:
stomach pains
Adverse symptoms may include the following:
pain or irritation
redness
blistering may occur
:
:
:
Eye contact
:
Adverse symptoms may include the following:
pain
watering
redness
Potential acute health effects
See toxicological information (Section 11)
Indication of immediate medical attention and special treatment needed, if necessary
Section 5. Fire-fighting measures
Specific hazards arising
from the chemical
In a fire or if heated, a pressure increase will occur and the container may burst.
Use an extinguishing agent suitable for the surrounding fire.
Extinguishing media
:
None known.
Suitable extinguishing
media
:
Unsuitable extinguishing
media
:
Date of issue/Date of revision
:
4/3/2020
Date of previous issue
:
4/2/2020
Version
:
1.11
3/14
Betco Symplicity Sanibet Multi-Range
Section 5. Fire-fighting measures
Promptly isolate the scene by removing all persons from the vicinity of the incident if
there is a fire. No action shall be taken involving any personal risk or without suitable
training.
Hazardous thermal
decomposition products
Decomposition products may include the following materials:
carbon dioxide
carbon monoxide
nitrogen oxides
halogenated compounds
metal oxide/oxides
Fire-fighters should wear appropriate protective equipment and self-contained breathing
apparatus (SCBA) with a full face-piece operated in positive pressure mode.
Special protective
equipment for fire-fighters
:
:
Special protective actions
for fire-fighters
:
Section 6. Accidental release measures
Environmental precautions
Personal precautions, protective equipment and emergency procedures
Stop leak if without risk. Move containers from spill area. Approach release from
upwind. Prevent entry into sewers, water courses, basements or confined areas. Wash
spillages into an effluent treatment plant or proceed as follows. Contain and collect
spillage with non-combustible, absorbent material e.g. sand, earth, vermiculite or
diatomaceous earth and place in container for disposal according to local regulations
(see Section 13). Dispose of via a licensed waste disposal contractor. Contaminated
absorbent material may pose the same hazard as the spilled product. Note: see
Section 1 for emergency contact information and Section 13 for waste disposal.
:
:
No action shall be taken involving any personal risk or without suitable training.
Evacuate surrounding areas. Keep unnecessary and unprotected personnel from
entering. Do not touch or walk through spilled material. Do not breathe vapor or mist.
Provide adequate ventilation. Wear appropriate respirator when ventilation is
inadequate. Put on appropriate personal protective equipment.
Avoid dispersal of spilled material and runoff and contact with soil, waterways, drains
and sewers. Inform the relevant authorities if the product has caused environmental
pollution (sewers, waterways, soil or air).
Large spill
:
Stop leak if without risk. Move containers from spill area. Dilute with water and mop up
if water-soluble. Alternatively, or if water-insoluble, absorb with an inert dry material and
place in an appropriate waste disposal container. Dispose of via a licensed waste
disposal contractor.
Small spill
:
Methods and materials for containment and cleaning up
For non-emergency
personnel
For emergency responders
:
If specialized clothing is required to deal with the spillage, take note of any information in
Section 8 on suitable and unsuitable materials. See also the information in "For nonemergency personnel".
Section 7. Handling and storage
Advice on general
occupational hygiene
Eating, drinking and smoking should be prohibited in areas where this material is
handled, stored and processed. Workers should wash hands and face before eating,
drinking and smoking. Remove contaminated clothing and protective equipment before
entering eating areas. See also Section 8 for additional information on hygiene
measures.
:
Protective measures
Put on appropriate personal protective equipment (see Section 8). Do not get in eyes or
on skin or clothing. Do not breathe vapor or mist. Do not ingest. If during normal use
the material presents a respiratory hazard, use only with adequate ventilation or wear
appropriate respirator. Keep in the original container or an approved alternative made
from a compatible material, kept tightly closed when not in use. Empty containers retain
product residue and can be hazardous. Do not reuse container.
:
Precautions for safe handling
Date of issue/Date of revision
:
4/3/2020
Date of previous issue
:
4/2/2020
Version
:
1.11
4/14
Betco Symplicity Sanibet Multi-Range
Section 7. Handling and storage
Conditions for safe storage,
including any
incompatibilities
Store in accordance with local regulations. Store in original container protected from
direct sunlight in a dry, cool and well-ventilated area, away from incompatible materials
(see Section 10) and food and drink. Store locked up. Keep container tightly closed
and sealed until ready for use. Containers that have been opened must be carefully
resealed and kept upright to prevent leakage. Do not store in unlabeled containers.
Use appropriate containment to avoid environmental contamination. See Section 10 for
incompatible materials before handling or use.
:
Quaternary ammonium compounds, benzyl-C12-16-alkyldimethyl,
chlorides
None.
decyldimethyloctylammonium chloride
None.
didecyldimethylammonium chloride
None.
ethanol
ACGIH TLV (United States, 3/2018).
STEL: 1000 ppm 15 minutes.
OSHA PEL 1989 (United States, 3/1989).
TWA: 1000 ppm 8 hours.
TWA: 1900 mg/m³ 8 hours.
NIOSH REL (United States, 10/2016).
TWA: 1000 ppm 10 hours.
TWA: 1900 mg/m³ 10 hours.
OSHA PEL (United States, 5/2018).
TWA: 1000 ppm 8 hours.
TWA: 1900 mg/m³ 8 hours.
dimethyldioctylammonium chloride
None.
Section 8. Exposure controls/personal protection
Ingredient name
Exposure limits
Hand protection
Chemical-resistant, impervious gloves complying with an approved standard should be
worn at all times when handling chemical products if a risk assessment indicates this is
necessary. Considering the parameters specified by the glove manufacturer, check
during use that the gloves are still retaining their protective properties. It should be
noted that the time to breakthrough for any glove material may be different for different
glove manufacturers. In the case of mixtures, consisting of several substances, the
protection time of the gloves cannot be accurately estimated.
Safety eyewear complying with an approved standard should be used when a risk
assessment indicates this is necessary to avoid exposure to liquid splashes, mists,
gases or dusts. If contact is possible, the following protection should be worn, unless
the assessment indicates a higher degree of protection: chemical splash goggles and/
or face shield. If inhalation hazards exist, a full-face respirator may be required instead.
Recommended: splash goggles
Eye/face protection
:
:
Environmental exposure
controls
:
Emissions from ventilation or work process equipment should be checked to ensure
they comply with the requirements of environmental protection legislation. In some
cases, fume scrubbers, filters or engineering modifications to the process equipment
will be necessary to reduce emissions to acceptable levels.
Appropriate engineering
controls
:
If user operations generate dust, fumes, gas, vapor or mist, use process enclosures,
local exhaust ventilation or other engineering controls to keep worker exposure to
airborne contaminants below any recommended or statutory limits.
Wash hands, forearms and face thoroughly after handling chemical products, before
eating, smoking and using the lavatory and at the end of the working period.
Appropriate techniques should be used to remove potentially contaminated clothing.
Wash contaminated clothing before reusing. Ensure that eyewash stations and safety
showers are close to the workstation location.
Hygiene measures
:
Control parameters
Individual protection measures
Occupational exposure limits
Skin protection
Date of issue/Date of revision
:
4/3/2020
Date of previous issue
:
4/2/2020
Version
:
1.11
5/14
Loading...