Betco 1921200 User Manual
Clear Image RTU
Not available.
Liquid.
Chemtrec (800) 424-9300 24 hour
SAFETY DATA SHEET
GHS product identifier
Other means of
identification
Product type
Emergency telephone
number (with hours of
operation)
Section 1. Identification
:
:
:
:
Supplier's details
: Betco Corporation
Clear Image RTU
Relevant identified uses of the substance or mixture and uses advised against
Not applicable.
Product code
:
192
Section 2. Hazards identification
Not classified.
Classification of the
substance or mixture
:
Signal word
:
No signal word.
Hazard statements
:
No known significant effects or critical hazards.
Precautionary statements
Prevention
:
Not applicable.
Response
:
Not applicable.
Storage
:
Not applicable.
Disposal
:
Not applicable.
GHS label elements
OSHA/HCS status
:
While this material is not considered hazardous by the OSHA Hazard Communication
Standard (29 CFR 1910.1200), this SDS contains valuable information critical to the
safe handling and proper use of the product. This SDS should be retained and available
for employees and other users of this product.
Hazards not otherwise
classified
:
None known.
Section 3. Composition/information on ingredients
There are no ingredients present which, within the current knowledge of the supplier and in the concentrations
applicable, are classified as hazardous to health or the environment and hence require reporting in this section.
Other means of
identification
:
Not available.
Substance/mixture
:
Occupational exposure limits, if available, are listed in Section 8.
Mixture
Any concentration shown as a range is to protect confidentiality or is due to batch variation.
Date of issue/Date of revision
:
11/13/2017
Date of previous issue
:
No previous validation
Version
:11/10
400 Van Camp Road
Bowling Green, Ohio 43402
www.betco.com
888-462-3826
Clear Image RTU
Wash out mouth with water. Remove victim to fresh air and keep at rest in a position
comfortable for breathing. If material has been swallowed and the exposed person is
conscious, give small quantities of water to drink. Do not induce vomiting unless
directed to do so by medical personnel. Get medical attention if symptoms occur.
Immediately flush eyes with plenty of water, occasionally lifting the upper and lower
eyelids. Check for and remove any contact lenses. Get medical attention if irritation
occurs.
Flush contaminated skin with plenty of water. Remove contaminated clothing and
shoes. Get medical attention if symptoms occur.
Remove victim to fresh air and keep at rest in a position comfortable for breathing. Get
medical attention if symptoms occur.
Section 4. First aid measures
Eye contact
Skin contact
Inhalation
Ingestion
:
:
:
:
Protection of first-aiders
:
No action shall be taken involving any personal risk or without suitable training.
Notes to physician
:
Treat symptomatically. Contact poison treatment specialist immediately if large
quantities have been ingested or inhaled.
Description of necessary first aid measures
Specific treatments
:
No specific treatment.
Most important symptoms/effects, acute and delayed
Inhalation
:
No known significant effects or critical hazards.
No known significant effects or critical hazards.
:
Ingestion
Skin contact
:
No known significant effects or critical hazards.
No known significant effects or critical hazards.
:
Eye contact
Over-exposure signs/symptoms
Skin contact
Ingestion
Inhalation
No specific data.
No specific data.
No specific data.
:
::Eye contact
:
No specific data.
Potential acute health effects
See toxicological information (Section 11)
Indication of immediate medical attention and special treatment needed, if necessary
Section 5. Fire-fighting measures
Promptly isolate the scene by removing all persons from the vicinity of the incident if
there is a fire. No action shall be taken involving any personal risk or without suitable
training.
Hazardous thermal
decomposition products
Specific hazards arising
from the chemical
No specific data.
In a fire or if heated, a pressure increase will occur and the container may burst.
Fire-fighters should wear appropriate protective equipment and self-contained breathing
apparatus (SCBA) with a full face-piece operated in positive pressure mode.
Special protective
equipment for fire-fighters
Use an extinguishing agent suitable for the surrounding fire.
Extinguishing media
:
:
:
None known.
Suitable extinguishing
media
:
Unsuitable extinguishing
media
:
Special protective actions
for fire-fighters
:
Date of issue/Date of revision
:
11/13/2017
Date of previous issue
:
No previous validation
Version
:12/10
Clear Image RTU
Section 6. Accidental release measures
Environmental precautions
Personal precautions, protective equipment and emergency procedures
Stop leak if without risk. Move containers from spill area. Prevent entry into sewers,
water courses, basements or confined areas. Wash spillages into an effluent treatment
plant or proceed as follows. Contain and collect spillage with non-combustible,
absorbent material e.g. sand, earth, vermiculite or diatomaceous earth and place in
container for disposal according to local regulations (see Section 13). Dispose of via a
licensed waste disposal contractor. Note: see Section 1 for emergency contact
information and Section 13 for waste disposal.
:
:
No action shall be taken involving any personal risk or without suitable training.
Evacuate surrounding areas. Keep unnecessary and unprotected personnel from
entering. Do not touch or walk through spilled material. Put on appropriate personal
protective equipment.
Avoid dispersal of spilled material and runoff and contact with soil, waterways, drains
and sewers. Inform the relevant authorities if the product has caused environmental
pollution (sewers, waterways, soil or air).
Large spill
:
Stop leak if without risk. Move containers from spill area. Dilute with water and mop up
if water-soluble. Alternatively, or if water-insoluble, absorb with an inert dry material and
place in an appropriate waste disposal container. Dispose of via a licensed waste
disposal contractor.
Small spill
:
Methods and materials for containment and cleaning up
For non-emergency
personnel
For emergency responders
:
If specialized clothing is required to deal with the spillage, take note of any information in
Section 8 on suitable and unsuitable materials. See also the information in "For nonemergency personnel".
Section 7. Handling and storage
Advice on general
occupational hygiene
Conditions for safe storage,
including any
incompatibilities
Eating, drinking and smoking should be prohibited in areas where this material is
handled, stored and processed. Workers should wash hands and face before eating,
drinking and smoking. Remove contaminated clothing and protective equipment before
entering eating areas. See also Section 8 for additional information on hygiene
measures.
Store in accordance with local regulations. Store in original container protected from
direct sunlight in a dry, cool and well-ventilated area, away from incompatible materials
(see Section 10) and food and drink. Keep container tightly closed and sealed until
ready for use. Containers that have been opened must be carefully resealed and kept
upright to prevent leakage. Do not store in unlabeled containers. Use appropriate
containment to avoid environmental contamination. See Section 10 for incompatible
materials before handling or use.
:
:
Protective measures
Put on appropriate personal protective equipment (see Section 8).
:
Precautions for safe handling
None.
Section 8. Exposure controls/personal protection
Environmental exposure
controls
:
Emissions from ventilation or work process equipment should be checked to ensure
they comply with the requirements of environmental protection legislation. In some
cases, fume scrubbers, filters or engineering modifications to the process equipment
will be necessary to reduce emissions to acceptable levels.
Appropriate engineering
controls
:
Good general ventilation should be sufficient to control worker exposure to airborne
contaminants.
Control parameters
Individual protection measures
Occupational exposure limits
Date of issue/Date of revision
:
11/13/2017
Date of previous issue
:
No previous validation
Version
:13/10
Loading...