Betco 0922302 User Manual
Clear Image Glass & Surface Cleaner
Not available.
Aerosol.
Chemtrec (800) 424-9300 24 hour
SAFETY DATA SHEET
GHS product identifier
Other means of
identification
Product type
Emergency telephone
number (with hours of
operation)
Section 1. Identification
:::
:
Supplier's details
:
Betco Corporation
400 Van Camp Road
Bowling Green, Ohio 43402
www.betco.com
888-462-3826
Clear Image Glass & Surface Cleaner
Relevant identified uses of the substance or mixture and uses advised against
Not applicable.
Product code
:
092
Section 2. Hazards identification
FLAMMABLE AEROSOLS - Category 1
GASES UNDER PRESSURE - Compressed gas
Classification of the
substance or mixture
:
Signal word
:
Danger
Hazard statements
:
Extremely flammable aerosol.
Contains gas under pressure; may explode if heated.
Hazard pictograms
:
Precautionary statements
Prevention
:
Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No
smoking. Do not spray on an open flame or other ignition source. Pressurized
container: Do not pierce or burn, even after use.
Response
:
Not applicable.
Storage
:
Protect from sunlight. Do not expose to temperatures exceeding 50 °C/122 °F. Store in
a well-ventilated place.
Disposal
:
Not applicable.
GHS label elements
Hazards not otherwise
classified
:
None known.
OSHA/HCS status
:
This material is considered hazardous by the OSHA Hazard Communication Standard
(29 CFR 1910.1200).
Date of issue/Date of revision
:
5/3/2019
Date of previous issue
:
No previous validation
Version
:11/13
Clear Image Glass & Surface Cleaner
Section 3. Composition/information on ingredients
2-butoxyethanol
≤10
111-76-2
ethanol
≤5
64-17-5
propane
≤3
74-98-6
Ingredient name
CAS number
%
There are no additional ingredients present which, within the current knowledge of the supplier and in the
concentrations applicable, are classified as hazardous to health or the environment and hence require reporting
in this section.
Other means of
identification
:
Not available.
Substance/mixture
:
Occupational exposure limits, if available, are listed in Section 8.
Mixture
Any concentration shown as a range is to protect confidentiality or is due to batch variation.
Wash out mouth with water. Remove dentures if any. Remove victim to fresh air and
keep at rest in a position comfortable for breathing. If material has been swallowed and
the exposed person is conscious, give small quantities of water to drink. Stop if the
exposed person feels sick as vomiting may be dangerous. Do not induce vomiting
unless directed to do so by medical personnel. If vomiting occurs, the head should be
kept low so that vomit does not enter the lungs. Get medical attention if adverse health
effects persist or are severe. Never give anything by mouth to an unconscious person.
If unconscious, place in recovery position and get medical attention immediately.
Maintain an open airway. Loosen tight clothing such as a collar, tie, belt or waistband.
Immediately flush eyes with plenty of water, occasionally lifting the upper and lower
eyelids. Check for and remove any contact lenses. Continue to rinse for at least 10
minutes. Get medical attention if irritation occurs.
Flush contaminated skin with plenty of water. Remove contaminated clothing and
shoes. Get medical attention if symptoms occur. Wash clothing before reuse. Clean
shoes thoroughly before reuse.
Remove victim to fresh air and keep at rest in a position comfortable for breathing. If
not breathing, if breathing is irregular or if respiratory arrest occurs, provide artificial
respiration or oxygen by trained personnel. It may be dangerous to the person providing
aid to give mouth-to-mouth resuscitation. Get medical attention if adverse health effects
persist or are severe. If unconscious, place in recovery position and get medical
attention immediately. Maintain an open airway. Loosen tight clothing such as a collar,
tie, belt or waistband.
Section 4. First aid measures
Eye contact
Skin contact
Inhalation
Ingestion
:
:::
Description of necessary first aid measures
Most important symptoms/effects, acute and delayed
Inhalation
:
No known significant effects or critical hazards.
No known significant effects or critical hazards.
:
Ingestion
Skin contact
:
No known significant effects or critical hazards.
No known significant effects or critical hazards.
:
Eye contact
Over-exposure signs/symptoms
Skin contact
Ingestion
Inhalation
Adverse symptoms may include the following:
respiratory tract irritation
coughing
No specific data.
No specific data.
:::
Eye contact
:
Adverse symptoms may include the following:
irritation
redness
Potential acute health effects
Date of issue/Date of revision
:
5/3/2019
Date of previous issue
:
No previous validation
Version
:12/13
Clear Image Glass & Surface Cleaner
Section 4. First aid measures
Protection of first-aiders
:
No action shall be taken involving any personal risk or without suitable training. It may
be dangerous to the person providing aid to give mouth-to-mouth resuscitation.
Notes to physician
:
Treat symptomatically. Contact poison treatment specialist immediately if large
quantities have been ingested or inhaled.
Specific treatments
:
No specific treatment.
See toxicological information (Section 11)
Indication of immediate medical attention and special treatment needed, if necessary
Section 5. Fire-fighting measures
Promptly isolate the scene by removing all persons from the vicinity of the incident if
there is a fire. No action shall be taken involving any personal risk or without suitable
training. Move containers from fire area if this can be done without risk. Use water
spray to keep fire-exposed containers cool.
Hazardous thermal
decomposition products
Specific hazards arising
from the chemical
Decomposition products may include the following materials:
carbon dioxide
carbon monoxide
Extremely flammable aerosol. Runoff to sewer may create fire or explosion hazard. In
a fire or if heated, a pressure increase will occur and the container may burst, with the
risk of a subsequent explosion. Gas may accumulate in low or confined areas or travel
a considerable distance to a source of ignition and flash back, causing fire or explosion.
Bursting aerosol containers may be propelled from a fire at high speed.
Fire-fighters should wear appropriate protective equipment and self-contained breathing
apparatus (SCBA) with a full face-piece operated in positive pressure mode.
Special protective
equipment for fire-fighters
Use an extinguishing agent suitable for the surrounding fire.
Extinguishing media
:
:
:
None known.
Suitable extinguishing
media
:
Unsuitable extinguishing
media
:
Special protective actions
for fire-fighters
:
Section 6. Accidental release measures
Environmental precautions
Personal precautions, protective equipment and emergency procedures
:
:
No action shall be taken involving any personal risk or without suitable training.
Evacuate surrounding areas. Keep unnecessary and unprotected personnel from
entering. In the case of aerosols being ruptured, care should be taken due to the rapid
escape of the pressurized contents and propellant. If a large number of containers are
ruptured, treat as a bulk material spillage according to the instructions in the clean-up
section. Do not touch or walk through spilled material. Shut off all ignition sources. No
flares, smoking or flames in hazard area. Avoid breathing vapor or mist. Provide
adequate ventilation. Wear appropriate respirator when ventilation is inadequate. Put
on appropriate personal protective equipment.
Avoid dispersal of spilled material and runoff and contact with soil, waterways, drains
and sewers. Inform the relevant authorities if the product has caused environmental
pollution (sewers, waterways, soil or air).
Methods and materials for containment and cleaning up
For non-emergency
personnel
For emergency responders
:
If specialized clothing is required to deal with the spillage, take note of any information in
Section 8 on suitable and unsuitable materials. See also the information in "For nonemergency personnel".
Date of issue/Date of revision
:
5/3/2019
Date of previous issue
:
No previous validation
Version
:13/13
Clear Image Glass & Surface Cleaner
Section 6. Accidental release measures
Stop leak if without risk. Move containers from spill area. Use spark-proof tools and
explosion-proof equipment. Approach release from upwind. Prevent entry into sewers,
water courses, basements or confined areas. Wash spillages into an effluent treatment
plant or proceed as follows. Contain and collect spillage with non-combustible,
absorbent material e.g. sand, earth, vermiculite or diatomaceous earth and place in
container for disposal according to local regulations (see Section 13). Dispose of via a
licensed waste disposal contractor. Contaminated absorbent material may pose the
same hazard as the spilled product. Note: see Section 1 for emergency contact
information and Section 13 for waste disposal.
Large spill
:
Stop leak if without risk. Move containers from spill area. Use spark-proof tools and
explosion-proof equipment. Dilute with water and mop up if water-soluble. Alternatively,
or if water-insoluble, absorb with an inert dry material and place in an appropriate waste
disposal container. Dispose of via a licensed waste disposal contractor.
Small spill
:
Section 7. Handling and storage
Advice on general
occupational hygiene
Conditions for safe storage,
including any
incompatibilities
Eating, drinking and smoking should be prohibited in areas where this material is
handled, stored and processed. Workers should wash hands and face before eating,
drinking and smoking. Remove contaminated clothing and protective equipment before
entering eating areas. See also Section 8 for additional information on hygiene
measures.
Store in accordance with local regulations. Store away from direct sunlight in a dry, cool
and well-ventilated area, away from incompatible materials (see Section 10) and food
and drink. Protect from sunlight. Eliminate all ignition sources. Use appropriate
containment to avoid environmental contamination. See Section 10 for incompatible
materials before handling or use.
:
:
Protective measures
Put on appropriate personal protective equipment (see Section 8). Pressurized
container: protect from sunlight and do not expose to temperatures exceeding 50°C. Do
not pierce or burn, even after use. Do not ingest. Avoid contact with eyes, skin and
clothing. Avoid breathing gas. Avoid breathing vapor or mist. Use only with adequate
ventilation. Wear appropriate respirator when ventilation is inadequate. Store and use
away from heat, sparks, open flame or any other ignition source. Use explosion-proof
electrical (ventilating, lighting and material handling) equipment. Use only non-sparking
tools. Empty containers retain product residue and can be hazardous.
:
Precautions for safe handling
2-butoxyethanol
OSHA PEL 1989 (United States, 3/1989).
Absorbed through skin.
TWA: 25 ppm 8 hours.
TWA: 120 mg/m³ 8 hours.
NIOSH REL (United States, 10/2016).
Absorbed through skin.
TWA: 5 ppm 10 hours.
TWA: 24 mg/m³ 10 hours.
ACGIH TLV (United States, 3/2017).
TWA: 20 ppm 8 hours.
OSHA PEL (United States, 6/2016).
Absorbed through skin.
TWA: 50 ppm 8 hours.
TWA: 240 mg/m³ 8 hours.
ethanol
ACGIH TLV (United States, 3/2017).
STEL: 1000 ppm 15 minutes.
OSHA PEL 1989 (United States, 3/1989).
TWA: 1000 ppm 8 hours.
TWA: 1900 mg/m³ 8 hours.
Section 8. Exposure controls/personal protection
Ingredient name
Exposure limits
Control parameters
Occupational exposure limits
Date of issue/Date of revision
:
5/3/2019
Date of previous issue
:
No previous validation
Version
:14/13
Loading...