Best ILB3 Specifications
IN-LINE BLOWER
HLB3
MODEL ILB3
SPECIFICATION SHEET
Powerful yet quiet blower - exhausts the cooking area
from a remote location.
FEATURES
BLOWER:
• Low RPM for quiet operation
• Resilient anti-vibration mounts
• Dynamically-balanced, galvanized steel, centrifugal
blower wheel for quiet, efficient performance
• Permanently lubricated, thermally protected motor
• Plug-in motor rated at 120 VAC
• Designed for continuous operation
• For indoor use only
HOUSING:
• Rugged galvanized steel
• 8-position mounting brackets for easy installation and
greater adaptability to various mounting requirements
• Automatic backdraft damper located within exhaust
duct connector
• Factory-shipped in horizontal discharge position
• May be converted to vertical discharge
• Suitable for kitchen installations
ACCESSORIES INCLUDED:
• 8-inch round integrated duct connectors
• One (1) 8-inch to 10-inch-round transition
• Hanger kit - for additional installation flexibility
• Range hood rough-in kit with integrated 10-inch duct
connector
SPECIFICATIONS
Volts Hz Amps CFM Duct Weight
120 60 2.6 260 (V) 8” Round * 30.6 lbs.
2.7 280 (H)
* Performance ratings include the addition of a 10” round
transition on inlet.
HVI-2100 CERTIFIED RATINGS comply with new testing
technologies and procedures prescribed by the Home
Ventilating Institute, for off-the-shelf products, as they are
available to consumers. Product performance is rated at 0.1
in. static pressure, based on tests conducted in a state-of-theart test laboratory. Sones are a measure of humanly-perceived
loudness, based on laboratory measurements.
BEST Hartford, Wisconsin www.BestRangeHoods.com 800-558-1711
BEST Drummondville, QC Canada www.BestRangeHoods.com 866-737-7770
TYPICAL SPECIFICATION
In-Line Blower shall be Best Model ILB3.
Unit shall have galvanized steel housing. Housing to have
adjustable mounting brackets.
Blower to include hanger kit, one (1) 8-inch to 10-inch-round
transition, 8-inch round integrated duct connectors, and a
range hood rough-in kit with integrated 10-inch duct connector.
Automatic backdraft damper to be located within exhaust duct
connector. Duct connectors, blower assembly and wiring plate
shall be adjustable for either horizontal or vertical installation.
Blower unit shall be removable from
housing and will have a galvanized
steel, centrifugal-type blower wheel.
Motor to be permanently lubricated
and mounted with resilient antivibration mounts.
Air delivery shall be no less than listed.
All air ratings shall be certified by HVI.
Unit to be UL and cUL listed.
1.2
1.1
1
0.9
0.8
0.7
0.6
0.5
0.4
STATIC PRESSURE (IN-WG)
0.3
0.2
0.1
0
0 50 100 150 200 250 300
AIR FLOW RATE (CFM)
8” ROUND
DUCT CONNECTOR
HORIZO NTAL
VERTI CAL
REFERENCE QTY. REMARKS Project
Location
Architect
Engineer
Contractor
Submitted by Date
01B 99043706F
Loading...