Besantek CABLE TRACER BST-CT103 Instruction Manual

CABLE TRACER

Filter Probe & Tone Generator

INSTRUCTION MANUAL

BST-CT103

INDEX PAGE

1. INTRODUCTION.................................................. 1

2. FILTER PROBE.................................................... 1-3

3. TONE GENERATOR............................................ 3-6

4. SPECIFICATION.................................................. 7-8

5. MAINTENANCE................................................... 8

-1-

1. INTRODUCTION

The BST-CT103 has been designed and tested according
to CE safety requirements for electronic measuring
apparatus, EN 61326-1 EN 61000-4-2 EN 61000-4-3
and other safety standard.
The BST-CT103 is designed to identify and trace wires or

cables within a group without damaging the insulation.

2. FILTER PROBE

A. Features

● Works with any Tone Generator to identify wires.

● Volume control for increasing sensitivity and
adjustable to suit work environment.

● 2 operation modes: Filter on / Filter off.

● The auto-off function (5 minutes) prevents battery
consumption.

● Power supply is available in any 9V battery with a
life of approximately 50 hours.

● A phone jack is designed for headset or handset.

● Flashlight function.

B. Instructions

● Connecting the tone generator.

In terminated working cables:

Connect one test lead to a terminated wire and the
other test lead to earth or equipment ground. (See

gure 1)

In unterminated or non-working cables:

Connect one test lead to an unterminated wire and
the other test lead to another unterminated wire.
Press the round " " button for more than 1 second

to turn on the lter probe. You can hear a short beep