Besa Lighting Scope User Manual

INSTALLATION GUIDE
Spotlight Elements using Model QF2 Series Hardware (For use with Besa low voltage lighting systems only)
QF2, Rev.4 9-10
IMPORTANT: READ ALL INSTRUCTIONS BEFORE INSTALLING. DISCONNECT POWER BEFORE INSTALLING OR RE-LAMPING.
6695 Taylor Rd. Blacklick, OH 43004
www.besalighting.com
INSTALLING LAMP & SHADE:
1. Insert the lamp into the socket assembly by aligning the pins with the socket holes, and gently pushing until the lamp seats. Use a 12-volt MR16 Shielded (glass covered lamp) 50-watt max.
NOTE:
May be used with a 50W Xenon Bi-Pin lamp.
2. Slide the shade over the lamp and socket assembly so that the holes in the shade align with the holes in the socket assembly. Insert thethree (3) threaded posts into the holes in the shade and thread the posts into the socket assembly.
NOTE: Fixture shown is for instructional purposes, stem length may vary.
Socket Assembly
MR16 Lamp
QF2
Threaded Post
Shade
1. Insert the post of the quick connect into the quick connect adapter.
2. Thread the top half of the conical section until it seats with the adapter.
3. Adjust fixture position; use caution not to loosen the conical section.
Quick Connect Adapter
Top Conical Section
ADJUSTMENT OF THE SPOTLIGHT ANGLE:
1. Using the Allen wrench provided, loosen the side set screws until the spotlight can move freely.
2. Orient the spotlight to the desired angle, and then retighten the side set screws.
Low voltage systems operate at higher amperage, which requires secure connections. A loose or bad connection can lead to overheating, so it is advised to check the connections after the first 1/2 hour of operation. If the connection is hot to the touch, remove the spotlight then reinstall securely.
Loading...