Page 1
INSTALLATION GUIDE
Spotlight Elements using Model QF5 Series Hardware
(For use with Besa low voltage lighting systems only)
QF5, Rev.4 9-10
IMPORTANT: READ ALL INSTRUCTIONS BEFORE INSTALLING.
DISCONNECT POWER BEFORE INSTALLING OR RE-LAMPING.
6695 Taylor Rd. Blacklick, OH 43004
www.besalighting.com
INSTALLING LAMP & SHADE:
1. Carefully push the shade on to the spring clip portion of the
socket assembly. Shade should be secure.
2. Place the lamp inside the shade so that the two pins
protrude through the back of the shade. Insert the
lamp into the socket assembly by aligning the pins
with the socket holes, and gently pushing until
the lamp seats.
Use a 12-volt MR16 Shielded (glass covered lamp)
50-watt max.
Note: May be used with a 50W Xenon Bi-Pin lamp.
MR16
Lamp
NOTE: Fixture shown is for instructional
purposes, stem length may vary.
Quick
Connect
Stem
Spring Clip
Socket
Assembly
Socket
Assembly
Handle
Shade
QF5
INSTALLING THE QUICK CONNECT:
1. Insert the post of the quick connect into the
quick connect adapter.
2. Thread the top half of the conical section until it
seats with the adapter.
3. Adjust fixture position; use caution not to loosen
the conical section.
Quick Connect
Adapter
Top Conical
Section
ADJUSTMENT OF THE SPOTLIGHT ANGLE:
1. While holding the quick connect stem, orient the
spotlight to the desired angle using the socket
assembly handle.
Low voltage systems operate at higher amperage,
which requires secure connections. A loose or bad
connection can lead to overheating, so it is advised
to check the connections after the first 1/2 hour of
operation. If the connection is hot to the touch,
remove the spotlight then reinstall securely.
Loading...