Besafe iZi Go User Manual
REARWARD-FACING
USER MANUAL
ECE R44 04
GROUP WEIGHT AGE
+
0
0-13 kg 0-12 m
1
Thank you for choosing BeSafe iZi Go
BeSafe has developed this seat with much care, to protect your
child during the first phase of her or his life.
It is important that you read this user manual BEFORE installing
!
your seat. Incorrect installation could endanger your child.
Contents
Vital information 3
Preparing to install 4
Rearward-facing belt installation 5
Removing the seat 6
Positioning the child 7
Using the iZi Go with a stroller 10
Removing and refitting the cover 12
Cleaning instructions 12
Warning: potential misuse 13
Important advice 14
Guarantee 15
Point of Sale information 15
Warning
Using the seat as a reclined cradle
!
• IMPORTANT! Keep for future reference.
• Never leave the child unattended.
• Do not use the seat as reclined cradle once your child can
sit unaided.
• This seat is not intended for prolonged periods of sleeping.
• It is dangerous to use this seat on an elevated surface.
• Always use the restraint system.
• Do not use the seat if any components are broken or missing.
EN 12790-2009
Vital information
• It is NOT ALLOWED to mount the seat in a front
passenger seat WITH AN ACTIVATED AIRBAG.
• iZi Go can only be installed rearward-facing with a
3-point car belt, approved according to UN/ECE
Regulation No.16 or other equivalent standards.
• iZi Go is approved for group 0+, rearward-facing from 0-13 kg.
• The child must always be secured with the internal harness
straps when seated in the child seat. The same applies to
carrying the seat and when using in combination with a stroller.
• The seat cover contains magnets in the areas with the orange
indications. Magnets can influence electronic equipment such
as pacemakers.
• If the child weighs over 13 kg. or the top of the head of the
child is above the seat or his shoulder height reaches above
the highest position of the shoulder straps, you will need to
change to a group 1 seat.
• The seat must always be replaced following an accident.
Although it may look undamaged, in the event of another
accident, it might not be able to protect your child as well as
it should.
• Prevent the seat from becoming trapped or weighed down by
luggage, seats and/or slamming doors.
• Before every use, make sure the harness is not damaged
or twisted.
• Make sure you can fit no more than one finger between the
harness and your baby (1cm).
• Make sure the car safety belt buckle runs in a straight line and
stays below the belt hook of the seat. See the p.13 example.
• If in doubt, consult either the child restraint manufacturer or
the retailer.
!
2 3
2
Preparing to install
Crucial parts
Carrying handle
Headrest
Handle release buttons (2x)
Shoulder straps (2x)
Harness buckle
Baby cushion
Hip belt hook (2x)
Crotch strap
Cover
Central adjuster
Sun canopy
Instruction label
Stroller release buttons (4x)
Rearward-facing belt installation
• It is NOT ALLOWED to mount the seat in a front
passenger seat WITH AN ACTIVATED AIRBAG.
1- Position the seat on the vehicle seat. Make sure the carrying
handle is in the carrying position (1).
(1)
2- Guide the hip belt of the 3-point-belt over the blue parts
through the hip belt hooks and fasten the seat belt with a
‘click’ (2).
click!
(2)
!
Shoulder belt hook
Harness height adjuster
Stroller adapter house
4 5
Loading...