BeSafe iZi-Comfort X3 User Manual

FORWARD-FACING

USER MANUAL

ECE R44 04

GROUP WEIGHT AGE

1 9-18 kg 9m-4y

1

Thank you for choosing BeSafe iZi Comfort.

BeSafe has developed this seat with much care, to protect your
child during the next phase of her or his life.

It is important that you read this user manual BEFORE installing

!

your seat. Incorrect installation could endanger your child.

Contents

Vital information 3
Preparing to install 4
Forward-facing belt installation 5
Removing the seat 7
Positioning of the child 7
Sleeping position 9
Removing and refitting the cover 10
Cleaning instructions 12
Warning: potential misuse 12
Important advice 13
Guarantee 14
Point of sale information 14

Vital information

• It is NOT ALLOWED to mount the seat in a front
passenger seat WITH AN ACTIVATED AIRBAG.

• iZi Comfort can be installed only forward-facing with
a 3-point car belt, approved to UN/ECE Regulation
No. 16 or other equivalent standards.

• iZi Comfort is approved in group 1, forward-facing from 9-18 kg.

• The harness straps must always be locked when the child is in
the seat.

• The harness straps must be tightened without slack and
not twisted.

• The seat cover contains magnets in the areas with the orange
indications. Magnets can influence electronic equipment
like pacemakers.

• When the child weighs over 18 kg or the shoulder height grows
above the highest position of the shoulder straps, the child must
change to a group 2/3 seat.

• After an accident, the seat must be replaced. Although it may
look undamaged, if you were to have another accident, the seat
may not be able to protect your child as well as it should.

• Prevent the seat from becoming trapped or weighed down by
luggage, seats and/or slamming doors.

• Before every use, make sure the harness is not damaged
or twisted.

• Make sure you can fit no more than one finger between the
harness and your baby (1cm).

• If in doubt, consult either the child restraint manufacturer or
the retailer.

!

2 3

Preparing to install Forward-facing belt installation

Crucial parts It is NOT ALLOWED to mount the seat in a front

passenger seat WITH AN ACTIVATED AIRBAG.

Release handle head rest
Belt clamp (2x)
Adjustable head rest

When mounting in the back seat of the vehicle, push the

1-

front seat of the vehicle forward as much as possible.
When mounting in the front seat of the vehicle, adjust the
back rest in an upright position.

!

Harness shoulder straps

2-

Harness buckle

Put the child seat on the seat of the
vehicle. Unlock the belt clamps (1).

Central adjuster

(2)

Belt tensioner

Reclining knob (2x)

3-

Release the release handle at the
back of the head rest and push
the head rest down while keeping
the head rest upright (2).

4-

Pull the hip belt around the bottom
base of the seat and click the car
belt in the buckle (3).

4 5

(1)

(3)