Bernstein 618.1127.305 Technical Data

Technical Data

Mechanical data

Enclosure Thermoplastic, glass fibre reinforced (UL 94-V0)
Cover Thermoplastic, glass fibre reinforced (UL 94-V0)
Actuator Lever (Zn die-casting), deep groove ball bearing 635-ZZ-SS
Ambient air temperature -30° C ... +80° C
Contact type 1 NC, 1 NO (Zb)
Mechanical life 10 x 10
Switching frequency ≤ 100 / min.
Assembly 4 x M5
Connection 4 screw connections (M3,5)

Conductor cross-sections

Cable entrance 1 x M20 x 1,5
Weight ≈ 0,16 kg
Installation position operator definable
Protection type IP65 acc. to EN 60529

ID for safety engineering

B10d 20 x 10

6

operating cycles

Solid: 0,5 ... 1,5 mm² or
Litz wire with ferrules: 0,5 ... 1,5 mm²

6

switching cycles

Actuation

By loosening the 4 screws the actuation assembly can be rotated in 90 degree increments such that 4 actuation directions are
possible. The actuation assembly is to be again fastened to the housing using the 4 screws.

Standards

VDE 0660 T100, DIN EN 60947-1, IEC 60947-1
VDE 0660 T200, DIN EN 60947-5-1, IEC 60947-5-1

EU Conformity

acc. to directive 2014/35/EU (Low-Voltage-Directive)

Approvals

CSAUS A300 (same polarity)

C

Notes

The degree of protection (IP code) specified applies solely to a property closed cover and the use of an equivalent cable gland
with adequate cable.

BERNSTEIN AG . Hans-Bernstein-Straße 1 . 32457 Porta Westfalica . www.bernstein.eu

Technical modifications and errors excepted.

The technical datasheet corresponds to the technical state as of 2017-05-12 and will not be removed in case of changes.

Page 2 of 2

6181127305 / 2278-17