Bernstein 601.6369.157 Technical Data

Technical Data

Safety switch

Series SEL – with separate actuator

Description SEL1-A1Z P0 Article number 6016369157

SEL1 A1Z P

PO Bet.

actuator travel

actuating force

start of travel

end of travel

bush

spring plate

Electrical Data

Conv. thermal current I
Rated operational voltage U
Rated operational current I
Direct opening action
Gap between NC-contacts

4 A

the

230 V AC; 200 V DC

e

2 A AC / DC

e

p

acc. to IEC/EN 60947-5-1, Annex K

Ⓣ

DIN EN 81-20

Short-circuit protective device Fuse 6 A gG

BERNSTEIN AG . Hans-Bernstein-Straße 1 .

Technical modifications and errors excepted.

The technical datasheet corresponds to the technical state as of 2018-03-07 and will not be removed in case of changes.

Page 1 of 2

Screw project:
4 mm at mounted condition;
including spring plate

6016369157 / 2159-18

Technical Data

Mechanical data

Enclosure PC (UL 94-V0) transparent
Cover PC (UL 94-V0) transparent
Actuator Separate actuator (PA66 Ultramid A3X2G5)
Ambient air temperature -30 °C ... +70 °C
Contact type 1 N.C.
Mechanical life 10 x 10
Switching frequency ≤ 30 / min.
Assembly Safety switch

Actuator
Connection 2 screw connections (M3,5)

Conductor cross-sections

Weight ≈ 0,02 kg
Installation position operator definable
Protection type IP20 acc. to EN 60529

Standards

6

operating cycles

2 x M4 thread rolling captive screws according to DIN 7500
2 x M4

Solid: 0,5 ... 1,5 mm² or
Litz wire with ferrules: 0,5 ... 1,5 mm²

VDE 0660 T100, DIN EN 60947-1, IEC 60947-1
VDE 0660 T200, DIN EN 60947-5-1, IEC 60947-5-1
EN 81-20, EN 81-50

EU Conformity

acc. to directive 2014/35/EU (Low-Voltage-Directive)

Approvals

TÜV SÜD

CSA

C

US

ASME

CULUS

CCC

Notes

The centre of the misalignment between the P0 actuator and the switch add up to 3

-0.4

mm.

Do not use switch as end stop.

Door switch to be used in elevator doors.

The switch must be so installed that the current-carrying metal parts can not be touched directly by hand!
The cable entry must be covered by additional measures at the installation site.

BERNSTEIN AG . Hans-Bernstein-Straße 1 .

Technical modifications and errors excepted.

The technical datasheet corresponds to the technical state as of 2018-03-07 and will not be removed in case of changes.

Page 2 of 2

6016369157 / 2159-18