Benro S4 User guide

Page 1
S4迷你型摄像云台
S4 Video Head
快装板锁定钮
QR Plate Locking Handle
把手
Pan Bar Han dl e
3
4
把手
Pan Bar Handle
快装板
QR (Quick Release) Plate
配1/4"&3/8"备用螺钉
1/4 -20 & 3/8" Sc rews"
俯仰锁定钮
Tilt Lock Handle
1
2
可滑动快装板安全 钮
QR Plate Re lease But to n
可滑动快装板安全 钮
QR Plate Re lease But to n
水平仪
Bubble Level
水平锁定钮
1/4"-20 & 3/8" screw
快装板锁定钮
QR Plate Locking Handle
简体中文
使用方法:
云台使用说明
快装板:(如图1所示)
快装板可实现水平移动+/-20mm,从0位 置到平衡最优位置,保证了平衡位置的 广度。
快装板安装及锁紧和可滑动快装板安 全钮 (如图2所示):
本快装夹锁紧系统设计有安全保 险 装置
可防止因人为原因导致误操作而 使器材 滑落。
云台俯仰调整 (如图3所示):
云台水平旋转及锁紧
:
(如图4所示)
俯仰锁定钮
Tilt Lock Handle
使用方法:
云台使用说明
快装板:(如图1所示)
快装板可实现水平移动+/-20mm,从0位 置到平衡最优位置,保证了平衡位置的 广度。
快装板安装及锁紧和可滑动快装板安 全钮 (如图2所示):
本快装夹锁紧系统设计有安全保 险 装置
可防止因人为原因导致误操作而 使器材 滑落。
云台俯仰调整 (如图3所示):
云台水平旋转及锁紧
:
(如图4所示)
水平锁定钮
QR Plate: (See figure 1)
An included quick release plate makes camera changes and transport easy. Each QR plate comes with both a 1/4” & 3/8” screw for your convenience. The unused screw is stored on the underside of the head.
QR Plate Mounting and Safety Release: (See figure 2)
Loosen Quick Release Plate Lock Lever and press the QR Safety Button to allow QR Plate to be removed. Attach Plate to bottom of Camera using the Mounting Screw then slide back on to Head. Slide and position for best balance and tighten QR Plate Lock Lever.
Tilt adjustment: (See figure 3)
A side mounted knob adjusts the tension of the drag on front-rear. tilt movements. Rotate to adjust with a camera mounted to find the most appropriate setting.
Pan adjustment: (See figure 4)
A pan Drag/Lock Lever provides both Drag and Locking control of horizontal head movement. NOTE: Pan bar handle can be mounted on either side of head.
Page 2
简体 中文
注 意 事 项 :
注意 事 项 :
感谢您选择百诺品 牌。 在使用百 诺
产品之前,请你仔 细阅读此注 意事项,
以避免任何意外损 失。
繁体 中文
注意 事 项 :
注意 事 项 :
感谢您选择百诺品 牌。 在使用百 诺
产品之前,请你仔 细阅读此注 意事项,
以避免任何意外损 失。
E ng l is h
E ng l is h
User Notice:
User Notice:
Thank you for choosing Benro. Please read this
general instruction sheet before using, to avoid any
accidental damage.
INSTRUCTIONS
INSTRUCTIONS
Benro Professional S4 Video Head
百诺专业摄像云台
说明书
说明书
使用此产品时, 请不 要超过规定
NO
NO
的最大承重。
MAX
MAX
使用此产品时,时 常确认产品 各 琐紧装置是处于琐 紧的安全状 态,
!
!
避免意外损坏相机 。
请勿在零下30度或高 于零上70度 的温度下使用本产 品, 不推荐在 海水中使用本产品 。
请勿长时间将产品 放置在太阳 下, 避免长时间将产品 放置在高温 下, 例如靠近汽车玻璃 数小时。
在公共场所使用本 产品时, 请勿 离人,避免小孩靠 近, 造成意外 伤害。在危险的地 方使用时, 请 谨慎操作。
禁止搭载设备(相 机)等一起 携 带移动。
NO
NO
使用此产品时, 请不 要超过规定
NO
NO
的最大承重。
MAX
MAX
使用此产品时,时 常确认产品 各 琐紧装置是处于琐 紧的安全状 态,
!
!
避免意外损坏相机 。
请勿在零下30度或高 于零上70度 的温度下使用本产 品, 不推荐在 海水中使用本产品 。
请勿长时间将产品 放置在太阳 下, 避免长时间将产品 放置在高温 下, 例如靠近汽车玻璃 数小时。
在公共场所使用本 产品时, 请勿 离人,避免小孩靠 近, 造成意外 伤害。在危险的地 方使用时, 请 谨慎操作。
禁止搭载设备(相 机)等一起 携 带移动。
NO
NO
Do not exceed the weight load capacity that
NO
NO
this product is rated for.
MAX
MAX
Always ensure the locks and devices are safety secured to avoid accidental damage of the
!
!
camera and other equipment.
Do not use this product at temperatures less than -20C or more than +60C (-4F to +140F). Not recommended to use in seawater.
Avoid leaving the product in high temperature areas for long periods of time.
Keep out of reach of children.
Remove the camera equipment from the tripod during transportation.
NO
S 4
迷你型摄像云台
S4 SERIES
在潮湿,泥沙,风 尘等环境中 使 用过后,一定要用 干布将琐紧 螺 牙, 和可能藏有泥沙 的部分清除 干净,可使用无水 酒精,消毒 酒 精,清洁剂等擦洗 。
为了人身安全,在 使用本产品 时, 请勿靠近高电压区 域, 或与强效 化学接触。
在潮湿,泥沙,风 尘等环境中 使 用过后,一定要用 干布将琐紧 螺 牙, 和可能藏有泥沙 的部分清除 干净,可使用无水 酒精,消毒 酒 精,清洁剂等擦洗 。
为了人身安全,在 使用本产品 时, 请勿靠近高电压区 域, 或与强效 化学接触。
Clean with mild detergent or alcohol to remove dirt, dust or sand from leg locks and threads. Clean and dry with a soft cloth.
For your own safety, do not place this product near any electrical power sources and/or chemical substances.
Loading...