
S2迷你型摄像云台
S2 Video Head
快装板锁定钮
QR Plate Locking Handle
3
4
把手
Pan Bar Hand le
快装板
QR (Quick Release) Plate
俯仰锁定钮
Tilt Lock Handle
1
2
快装板锁定钮
QR Plate
Locking Handle
把手
Pan Bar Hand le
可滑动快装板安 全钮
QR Plate Relea se B ut to n
水平仪
Bubble Level
水平锁定钮
Pan Lock Handle
俯仰锁定钮
Tilt Lock Handle
简体中文
使用方法:
云台使用说明
快装板:(如图1所示)
快装板可实现水平移动+/-20mm,从0位
置到平衡最优位置,保证了平衡位置的
广度。
快装板安装及锁紧和可滑动快装板安
全钮 (如图2所示):
本快装夹锁紧系 统设计有安全保险 装置
可防止因人为原 因导致误操作而使器材
滑落。
云台俯仰调整 (如图3所示):
云台水平旋转 及锁紧
:
(如图4所示)
水平锁定钮
Pan Lock Handle
使用方法:
云台使用说明
快装板:(如图1所示)
快装板可实现水平移动+/-20mm,从0位
置到平衡最优位置,保证了平衡位置的
广度。
快装板安装及锁紧和可滑动快装板安
全钮 (如图2所示):
本快装夹锁紧系 统设计有安全保险 装置
可防止因人为原 因导致误操作而使器材
滑落。
云台俯仰调整 (如图3所示):
云台水平旋转 及锁紧
:
(如图4所示)
QR Plate: (See figure 1)
An included quick release plate makes
camera changes and transport easy.
QR Plate Mounting and Safety
Release:
(See figure 2)
Loosen Quick Release Plate Lock Lever
and press the QR Safety Button to allow
QR Plate to be removed. Attach Plate to
bottom of Camera using the Mounting
Screw then slide back on to Head. Slide
and position for best balance and tighten
QR Plate Lock Lever.
Tilt adjustment: (See figure 3)
A side mounted knob adjusts the tension
of the drag on front-rear. tilt movements.
Rotate to adjust with a camera mounted
to find the most appropriate setting.
可滑动快装板安 全钮
QR Plate Relea se B ut to n
Pan adjustment: (See figure 4)
A pan Drag/Lock Lever provides both
Drag and Locking control of horizontal
head movement.

简体 中文
注 意 事 项 :
注意 事 项 :
感谢您选择百诺品牌。 在使用百诺
产品之前,请你仔细阅读此注意事项,
以避免任何意外损失。
繁体 中文
注意 事 项 :
注意 事 项 :
感谢您选择百诺品牌。 在使用百诺
产品之前,请你仔细阅读此注意事项,
以避免任何意外损失。
E ng l i s h
User Notice:
User Notice:
Thank you for choosing Benro. Please read this
general instruction sheet before using, to avoid any
accidental damage.
INSTRUCTIONS
Benro Professional S2 Video Head
百诺专业摄像云台
说明书
说明书
使用此产品时, 请不要超过规定
NO
NO
的最大承重。
MAX
MAX
使用此产品时,时常确认产品各
琐紧装置是处于琐紧的安全状态,
!
!
避免意外损坏相机。
请勿在零下30度或高于零上70度
的温度下使用本产品, 不推荐在
海水中使用本产品。
请勿长时间将产品放置在太阳下,
避免长时间将产品放置在高温下,
例如靠近汽车玻璃数小时。
在公共场所使用本产品时, 请勿
离人,避免小孩靠近, 造成意外
伤害。在危险的地方使用时, 请
谨慎操作。
禁止搭载设备(相机)等一起携
带移动。
NO
NO
使用此产品时, 请不要超过规定
NO
NO
的最大承重。
MAX
MAX
使用此产品时,时常确认产品各
琐紧装置是处于琐紧的安全状态,
!
!
避免意外损坏相机。
请勿在零下30度或高于零上70度
的温度下使用本产品, 不推荐在
海水中使用本产品。
请勿长时间将产品放置在太阳下,
避免长时间将产品放置在高温下,
例如靠近汽车玻璃数小时。
在公共场所使用本产品时, 请勿
离人,避免小孩靠近, 造成意外
伤害。在危险的地方使用时, 请
谨慎操作。
禁止搭载设备(相机)等一起携
带移动。
NO
NO
Do not exceed the weight load capacity that
NO
NO
this product is rated for.
MAX
MAX
Always ensure the locks and devices are safety
secured to avoid accidental damage of the
!
!
camera and other equipment.
Do not use this product at temperatures less
than -20C or more than +60C (-4F to +140F).
Not recommended to use in seawater.
Avoid leaving the product in high temperature
areas for long periods of time.
Keep out of reach of children.
Remove the camera equipment from the tripod
during transportation.
NO
S
2
迷你型摄像云台
S2 SERIES
在潮湿,泥沙,风尘等环境中使
用过后,一定要用干布将琐紧螺
牙, 和可能藏有泥沙的部分清除
干净,可使用无水酒精,消毒酒
精,清洁剂等擦洗。
为了人身安全,在使用本产品时,
请勿靠近高电压区域, 或与强效
化学接触。
在潮湿,泥沙,风尘等环境中使
用过后,一定要用干布将琐紧螺
牙, 和可能藏有泥沙的部分清除
干净,可使用无水酒精,消毒酒
精,清洁剂等擦洗。
为了人身安全,在使用本产品时,
请勿靠近高电压区域, 或与强效
化学接触。
Clean with mild detergent or alcohol to remove
dirt, dust or sand from leg locks and threads.
Clean and dry with a soft cloth.
For your own safety, do not place this product
near any electrical power sources and/or
chemical substances.