Benro KH26NL, KH25N User manual
USER NOTICE
• Do not exceed the maximum speci ed
load capacity (see speci
www.BenroUSA.com).
• Always ensure that Leg and Head Locks
are tightly engaged before mounting any
gear on your Tripod.
• Always clean and dry any Tripod after it
has been exposed to wet, dusty, sandy
or salty conditions. Your Tripod is not
recommended for use in salt water. If
required, clean tripod using a mild soap
solution applied with a soft cloth, rinse
with fresh water and dry with soft towel.
Remove any dust, dirt or
Locks, Leg Sections and all moving parts.
• Do not leave any Tripod in the sun for
prolonged periods and avoid high
temperature exposure.
• Avoid leaving any Tripod or Monopod
unattended in areas where people could
trip over the gear an d get hurt.
• Remove camera, lens, and all gear from
Operating Instructions & User Notice
any tripod when transporting.
• For your safety, don’t let your Benro
gear come in contact with any electrical
power source.
cations at
Operating Instructions
Thank you for making Benro your choice for professional photographic
equipment. Your Benro gear is manufactured to provide years of
dependable service. In order to obtain optimum satisfaction and
performance, we suggest that you carefully read these instructions.
sand from all Leg
Video Tripod Kits
75 Virginia Road
North White Plains, NY 10603
T 914.347.3300
F 914.347.3309
info@BenroUSA.com
BenroUSA.com
Specifications and design are subje ct
to change without notice.
AD71FK5
Tilt Drag/Lock Lever
Operation:
Alternate Pan Arm Mount
Pan Drag/Lock Lever
Leg Lock Levers
Spre ad er
Retrac ta bl e Ru bb er
Feet wit h Sp ik es
Pan Arm
Head Lock Handle
Remo va bl e QR P la te
Tripod
Pull Tab on circular Locking Clip, then spread Legs
to full open position.
Loosen Pan Arm Locking Lever and raise Arm to
comfortable position, then re-lock.
Flip Leg Lock Levers down and slide Leg sections
to adjust height. Flip Levers up to lock.
Loosen Quick Release Plate Lock Lever and press the
QR Safety Button to allow QR Plate to be removed. Attach
Plate to bottom of Camera using Mounting Screw then
slide back on to Head. Slide and position for best balance
and tighten QR Plate Lock Lever.
Rotate Rubber Foot clockwise to expose Spikes for
outdoor use. Use Rubber Feet indoors.
Loosen Head Lock Handle and pivot Head in Bowl
of Tripod until it is level, then tighten.
QR Plate Safety Bu tton
QR Plate L oc k Le ve r
Pan Arm L oc k Le ve r
Head
Pan Drag/Lock Lever provides both Drag and
Locking control of horizontal head movement.
Tilt Drag/Lock lever provides both Drag and Locking
control of vertical head movement.
Pan Arm can be removed and positioned on
opposite side of head. An optional Pan Arm can also
be mounted to provide dual control.
Loading...