Bendix Commercial Vehicle Systems SMARTIRE TPMS COMPATIBILITY CHART User Manual

SmarTire™ Tire Pressure Monitoring System (TPMS) Software Compatibility Chart

For all congurations below, always upgrade to the highest software/hardware revision for the gauge/receiver combination.

Revision and software information can be read on the gauge during start-up.

Gauge

Version

200-0179

If you have:

Receiver Model 200-0184

(See white label on housing for model

number)

Receiver Model 200-0180

(See white label on housing for model

number)

Rev X-X *Software (SW):

4.26, 3.17

Rev 1-3 SW: 3.13, 2.2

Rev 1-2 SW: 3.11, 2.17

Rev 1-1 SW: 3.09, 2.15

Rev 1-0 SW: 3.08, 2.15

Rev 1-2 SW: 1.18, 1.5

Rev 1-1 SW: 1.15,1.5

Rev 1-0 SW: 2.18, 2.09

Software

Can Be

Upgraded

Where shown

Rev 1.2 SW: 1.6

No Yes Yes

Yes

No No No No

Software

Can Be

Upgraded

From 1.6 to

No No No No

2.1

Rev 1.3

**SW: 2.1

Yes

(See Note 3)

A Hardware

Change was

Implemented:

Software

cannot be

Upgraded from

2.1 to 3.0

<|>

Rev 1.4 SW: 3.0

Yes

(See Note 2)

(See Note 1)

Yes

(See Note 3)

Software

Can Be

Upgraded

From 3.0 to

4.1

A Hardware

Upgrade is

Required for

No No No No

Additional

Features

No No No No

Rev 2.0 SW: 4.1

Yes

Note: Legacy Receiver Model 200-0153 is not compatible with any of the above.

SmarTire™ TPMS Compatibility Chart Notes

*SW: 4.26, 3.17 Limited release; for specic customer applications only; contact Bendix CVS for availability.

REV 1.3 **SW: 2.1

Note 1: Some Features not compatible

Note 2: CAN communication limitation; some features not supported

Note 3: DTC format change

Gauges with SW Version 2.1 or older should be upgraded to Version 2.2 part # 248.0087; contact Bendix CVS for upgrade instructions; does not apply to Version 3.0 or higher.

J1939 Receiver Version 1-3 does not have features such as trailer monitoring and multi-tire autolearn. Software upgrade on receiver is required to access these additional features.

1. This version of receiver is able to send RTS/CTS and BAM sessions simultaneously but the gauge does not support this. This will cause the gauge to initialize improperly.

2. This version of receiver has features such as trailer monitoring and multi-tire autolearn which this version of the gauge does not support. Software upgrade is required to access these additional features.

Because the DM1 version is not recommended by the SAE standard, it is recommended to upgrade receiver to R1-3, which uses latest DTC format and includes additional enhancements.

a member of the Knorr-Bremse Group

For more information call: 1-800-AIR-BRAKE

1-800-247-2725 • www.bendix.com

BW2825