BENDIX TCH-003-043 User Manual
Technical Bulletin
Bulletin No: TCH-003-043-A Effective Date: 11/28/00 Cancels: NA Page: 1 of 1
Subject:
Bendix Commercial Vehi cle Syste ms changed all QR-1, QR-N 2, and QR-1 C quick release valves having a
maximum differential of 1 PSI (TMC I.D. QRV-010) to be zero hysteresis (TMC I.D. QRV-000). All valves
having a differential greater than the 1 PSI maximum were not impacted by this change. This change was
implemented on 10-15-97 as a product improvement for both service and park brake systems. Bendix and other
industry groups recommend that the pressure at all axles of a combination be within 2 PSI for control line
pressures of 10-40 PSI (Ref: BW-1555). This pressure balance promotes brake balance provided other factors
such a brake type, friction formulation, tires, etc. are sized properly per the gross axle weight regulations
(GAWR).
SAE J1859 defines hysteresis as the difference in the increasing and decreasing input pressure for a given output
(delivery) pressure. Conventional quick release valves with hysteresis can have a differential (difference between
inlet and outlet pressure) as high as 20 PSI on release. The zero hysteresis enables the output pressure to be equal
for both increasing and decreasing pressures. This improves the pneumatic brake balance on release and enables
the recommendations for pneumatic brake balance to be met.
The quick release valves manufactured by Bendix are flow sensitive devices that require a certain flow rate to
provide quick exhausting of air pressure. Because of the nature of its operation, line sizes and delivery volume are
critical to rapid exhausting of the delivery pressure.
Bendix recommends 3/8” tubing (outside diameter) minimum for Supply, Balance and Delivery lines for
these Quick Release Valves. If smaller line sizes are to be used, or if the venting of supply pressure is restricted
by other components, BCVS recommends that the zero hysteresis type quick release valves not be used to ensure
proper quick release function.
ZERO HYSTERESIS QUICK RELEASE VALVE
Bendix has released the following quick release valve part numbers with a 1 PSI maximum differential for use
with smaller line sizes and unique application. These are not zero hysteresis quick release valves.
Port Size (NPT)
Part Number Model
5009069 QR-1C 3/8 3/8 ¼ -5008064 QR-1C ¼ 3/8 ¼ -5009070 QR-1C ¼ ¼ ¼ -5009071 QR-1 3/8 ¼ -- -5009009 QR-1 3/8 3/8 -- 3/8
5009073 QRN-2 3/8 3/8 -- --
Supply Delivery Balance Exhaust
Loading...