BENDIX TCH-003-041 User Manual
Technical Bulletin
Bulletin No: TCH-003-041-A Effective Date: 7/8/97 Cancels: N/A Page: 1 of 2
Subject: MV-3 DASH CONTROL MODULE
Bendix Commercial Vehicle Systems LLC produces the
popular MV-3 Dash Control Module for the medium and
heavy duty trucking industry. We take pride in
maintaining high quality levels in all our products, but
have identified a batch of MV-3 valves with potential for
the SUPPLY-11 port to crack during installation. See the
installation instructions below for our full recommended
procedure.
The factors leading to this issue have been thoroughly
investigated and resolved. We continue to improve our
engineering and manufacturing processes to give our
customers the best quality at the right price.
Figure 1: MV-3 D ash Control Module
General Note: Non-metallic Valve Installation
Our recommended procedure when installing air lines to any non-metallic valve is as
follows:
• Use a liquid thread sealant on the fitting;
• Attach the fittings until they are hand-tight;
• Tighten the fittings approximately one and one half turns or
using a maximum of 10 ft.-lbs. torque;
• If further installation steps involve the fitting (e.g. when
attaching an air hose), use a wrench to hold the fitting body
so that no further force is applied to the valve port.
Note: Typically these ports have tapered thread, so excessive force will damage the
thread, the valve and may crack the port.
Figure 2: Manufacture Date Location Figure 3: SUPPLY 11 Port Location
Warranty Coverage
To be eligible for warranty coverage, check that all three of the following points apply:
(a) The MV-3 valve has threaded supply and delivery ports (not push-to-connect); and
(b) The date of manufacture is between 1/95 and 5/97. The date of production can be found by
looking at the valve body between the mounting plate, SUPPLY-12 and DEL-22 ports (see
Figure 2). The year of manufacture is the number shown at the center of the dial, and the arrow
points to the mont h of manufacture; and
(c) The port that has cracked is the SUPPLY-11 port.
To help customers experiencing this specific issue, we are offering a special warranty coverage
period thro ugh September 1, 2000. Items (a), (b) and (c) above must all apply to qualify for this
special warranty coverage (parts and labor at standard rate). Note: We are unable return any parts
rejected.
If you have any questions, please contact your Account M anager.
Loading...