speaker trio
Contents
English Page 4
Canadian Fran
is Page 11
Español Page 19
English
Power on / Power off
Base : Press the power button to turn on the base of
Speaker Trio. The Bluetooth© indicator will light up
to signify the unit is on and ready to be paired. Press
the power button again to turn off the base and the
Bluetooth indicator light will go out.
Speakers: Press the power button to turn the speaker
on. The white light on the base will light up to signify
the unit is on. Press the power button again to turn off
the speaker and the white base light will also go out.
Please note, always make sure to
turn on the
base unit before turning on the speakers
Play modes
Bluetooth mode: play an audio signal from the
connected Bluetooth© device.
AUX mode: play an audio signal from the connected
"wired" device.
Please note, if an Aux cable is connected to the
speaker it will not play music from Bluetooth©
connected devices.
Audio Use
Follow the above connection steps to pair a
Bluetooth© device with the Speaker Trio. At this point
you can send any kind of audio signal to your speaker
(music, video, gaming, etc.). Just use your device as
normal and the audio will play through your Speaker
Trio.
Controls
Pressing the + and - buttons will increase or decrease
the volume on the Speaker Trio. Please note that this
will not effect the volume levels on the connected
device.
Connection
Laptop / notebook / PC
As the Bluetooth© versions for these types of devices
varies greatly, the connection methods will differ
Operation Details
as well. If you can not connect with the Speaker Trio
using the previous method instructed you may need to
install a new version of the Bluetooth© driver. Please
reference the instructions of device for details.
Speaker Placement
The 3 individual speakers can be removed from
the Speaker Trio base to be set anywhere you like.
Approximate range is 80ft away from the base. The
Speaker Trio uses 5.8gHz signal so you're free to put
the speakers where you like!
AUX out
The Speaker Trio can also be used as a “bridge” to
wirelessly connect your devices to other speakers not
enabled with Bluetooth©.
Plug one end of the supplied Aux cable to the “AUX
OUT” port in the back of unit and plug the other end of
the cable to an “AUX IN” or “Line In” port on any other
speaker system
Please note, volume + & volume - on the Speaker Trio
lose function on this occasion and only the connec
ted
Bluetooth© device or the connected speaker itself can
control the volume.
Charging
Connect your Speaker Trio base to an outlet using the
included power adapter. Place the speakers onto the
charging area of the base. The red backlight will slowly
flash during charging and goes out when it has reached
a complete charge (Approx. 3.5 hours).
Issue: Pairing is unsuccessfully after multiple attempts
Solution:
Check if the Bluetooth© indicator light is on. If the indicator light is off, please press the power button
to turn the unit on. If the Bluetooth© indicator light still doesn’t come on after pressing the power
button, please charge the unit.
Check for other Bluetooth© devices around the surroundings that may interfere with searching and
turn devices off.
Power off and then power on the unit to restart the Bluetooth© function of the unit or your Bluetooth
device
Unplug any cables plugged into the AUX IN, restart all devices and then attempt pairing again.
Issue: Interference or static during playback
Solution:
Avoid using the device between concrete or other building structures that may interfere with the
signal.
Please check if the battery level of the unit and the Bluetooth© device and charge if necessary.
For more troubleshooting help go to http://bemwireless.com
Storage
Power off the Outlet Speaker If the unit will not be used for an extended period of time.
Do not set the unit in a damp environment, high temperatures or in direct sunlight.
Troubleshooting
Maintenance
Power off the unit
Use a soft, dry, lint-free cloth and wipe gently
Do not use alcohol, benzene, thinners or other chemical detergents as these can cause the casing to
be warped or discolored
Operation Details (cont.)
Charging Indicator Light Modes
Red LED / Flashing Fast: Battery is low, charge the unit soon.
Red LED / Flashing Slow: Speaker Trio is charging
Red LED / Turned Off: Battery is fully charged
Note: if the unit has not been used in the past 7 days please charge for 10 minutes before using the Speaker Trio.
6 7
FCC STATEMENT
Technical Parameters
•
Always position the unit on a stable and
level surface. Unstable surface can cause the
unit to topple and fall, resulting in possible
damage or injury
•
Do not drop, unpack, open, beat, curve,
prink and burn the unit
•
Avoid using the unit nearby basins or sinks
where it may come in contact with water
•
Do not place any ware with full water on the
top of the unit, such as vase, glass, pot, and
please avoid placing candle on the speaker
surface as well
•
Protect the using of the unit from any
overheating devices (such as radiator,
heating installation, cooking stove or other
heating devices)
•
Regardless of what reasons cause the unit
damage, please ask for the maintenance
personnel to repair
•
If you want to do the cleaning, please turn
off the unit and unplug the power cable
from the outlet first
Safety Instructions
• Set the volume properly to prevent injury to
the unit and your personal health
WARNING:
•
The battery (battery or batteries or battery
pack) shall not be exposed to excessive heat
such as sunshine, fire or the like.
•
No naked flame sources, such as lighted
candles, should be placed on the apparatus.
•
CAUTION: Danger of explosion if battery is
incorrectly replaced. Replace only with the
same or equivalent type.
be¯m wireless
http://bemwireless.com/
be¯m wireless LLC.
1725 Kilkenny Ct.
Woodstock, IL. USA
Made in China
For questions, comments or to purchase more be¯m wireless products go to:
bemwireless.com
You can also follow us at:
More Info
facebook.com/bemwireless
twitter.com/bemwirelessco
youtube.com/bemwireless
For information on your product's warranty go to:
bemwireless.com/support
Note: All specifications are subject to change without
notice.
Product Name: Speaker Trio
Model: HL2737
Power Supply: 5V 2.4A
Battery capacity: 3.7V 1800mAh
Output power: 2W X 3
Bluetooth Profile Supported: A2DP, AVRCP
Working range:Approximately 40ft of Bluetooth
range and 80ft of wireless speaker range
Working atmosphere: 0˚C-40˚C / 20%-90%RH
English
This product is specially designed based on the
full attention to safety; in order to make sure
the accident-free operation, please abide the
guidelines listed below:
Correct Disposal of this product.
This marking indicates that this
product should not be disposed
with other household wastes
throughout the EU. To prevent
possible harm to the environment or
human health from uncontrolled
waste disposal, recycle it
responsibly to promote the
sustainable reuse of material
resources. To return your used
device, please use the return and collection
systems or contact the retailer where the product
was purchased. They can take this product for
environmental safe recycling.
1. This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful
interference.
(2) This device must accept any interference
received, including interference that may
cause undesired operation.
2. Changes or modifications not expressly
approved by the party responsible for
compliance could void the user's authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation.
This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or
television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV
technician for help.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits
set forth for an uncontrolled environment. This equipment
should be installed and operated with minimum distance
20cm between the radiator & your body.
Frequency response：5.730 - 5.805 GHZ
Loading...