Belson DS-623 User Manual

PROFESSIONAL TURBO DRYER (Pages 1-5)
SECADOR PROFESIONAL TURBO (Páginas 6-10)
SAVE THIS USE AND CARE BOOK
CONSERVE ESTE INSTRUCTIVO
?
U.S.A./CANADA: 1-203-926-3230
2
1
When using electrical appliances, especially when children are present, basic safety precautions should always be followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING.
KEEP AWAY FROM WATER.
DANGER - As with most electrical appliances, electrical parts are electrically live
even when the switch is off.
To reduce the risk of death by electrical shock:
Always "unplug it" immediately after using.
Do not use while bathing.
Do not place or store appliance where it can fall or be pulled into tub or sink.
Do not place in or drop into water or other liquid.
If an appliance falls into water, "unplug it" immediately. Do not reach into the water.
WARNING - To reduce the risk of burns, electrocution, fire, or injury to persons:
Do not leave appliance unattended while it is operating or is plugged in.
Close supervision is necessary when this appliance is used by, on, or near children
or invalids.
Use this appliance only for its intended use as described in this manual. Do not use attachments not recommended by the manufacturer.
Never operate this appliance if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged in any manner or dropped into water. Take appliance to the nearest service facility for examination and repair or mechanical adjustment.
Keep the cord away from hot or heated surfaces. Do not wrap the cord around the appliance.
Never block the air openings of the appliance or place it on a soft surface, such as a bed, pillow or couch, where the air openings may be blocked. Keep air openings free of lint, hair, etc.
Never use while sleeping or while drowsy.
Never drop or insert any object into any opening.
Do not use outdoors or operate where aerosol (spray) products are being used.
Do not operate where oxygen is being administered.
Do not direct hot air toward eyes or other heat-sensitive areas.
Attachments will be hot during use. Allow them to cool before handling.
Do not place appliance on any surface while it is operating or while switch
is turned on.
While using the appliance, keep your hair out of it. Keep your hair away from the air inlets.
Do not operate with a voltage converter.
Do not use an extension cord with this appliance.
Cool Shot
ALCI (Appliance Leakage Current Interrupter)
Reset Button
Test Button
Cord; keep loosely coiled
Hanging Ring
Non-slip Rubber Insert
Heating Section
Air Output
Removable Air Intake Grille; keep free of lint and hair
High/Off/Low Switch (II/0/I)
Low/High Heat Switch (I/II)
Contoured Handle
IMPORTANT SAFEGUARDS
SAVE THESE INSTRUCTIONS
OPERATING INSTRUCTIONS
PRODUCT MAY VARY SLIGHTLY FROM ILLUSTRATIONS
POLARIZED PLUG
This appliance has a polarized plug (one blade is wider than the other). As a safety feature, this plug fits in a polarized outlet only one way. If the plug does not fit into the outlet, reverse the plug and try again. If it still does not fit, contact a qualified electrician. Do not attempt to defeat this safety feature.
LINE CORD SAFETY TIPS
1. Never pull or yank on the cord or the appliance.
2. To insert plug, grasp it firmly and guide it into outlet.
3. To disconnect appliance, grasp plug and remove it from outlet.
4. Before each use, inspect the line cord for cuts and/or abrasion marks. If any are found, this indicates that the appliance should be serviced and the line cord replaced. Please return it to our Service Department or to an authorized service representative.
5. Never wrap the cord tightly around the appliance, as this could place undue stress on the cord where it enters the appliance and cause it to fray and break.
DO NOT OPERATE APPLIANCE IF THE LINE CORD SHOWS ANY DAMAGE, OR IF APPLIANCE WORKS INTERMITTENTLY OR STOPS WORKING ENTIRELY.
Air Concentrator
4
3
This appliance is equipped with an ESP®Electric Shock Protector™, specifically engineered for safety. It is for household use and may be plugged into any AC electrical outlet (ordinary household current). Do not use any other electrical outlet.
HOW ESP®WORKS
This unit is provided with an appliance leakage current interrupter (ALCI) safety device built into the plug. This device will make it inoperable under some abnormal conditions, such as accidental immersion in water. If the appliance is immersed in water, do not attempt to reset the ALCI safety device. Please take the unit to the nearest service facility for examination.
The ALCI safety device is equipped with a test button so that its operation can be checked.
TO USE:
1. Press the reset button on the ALCI safety device.
2. Plug appliance into AC electrical outlet.
3. Then press the test button. The reset button will pop out. This verifies that the safety device is operating properly. Should the reset button not pop out, do not use the
unit. Return immediately for service.
4. Press the reset button to re-activate the ALCI safety device and use the appliance.
Repeat the above procedure each time this appliance is used to confirm that the safety device is operational.
At any time, should this unit detect an electrical shock hazard, it will immediately shut off. To restore power, the reset button on the ALCI safety device must be pressed to reactivate the circuit.
IMPORTANT: Never block air intake grille, as this will cause the unit to overheat. Should this happen, a built-in safety system will operate, and the unit will start blowing warm air. At this
point, turn the switch to Off, and clear any obstruction from the air intake grille. Wait 10 minutes before attempting to operate the appliance again. If the unit fails to operate, it may indicate that the appliance has sustained extensive damage. Do not try to repair it yourself. Take it to an electrical service facility, or return it to the manufacturer. See warranty for instructions.
CAUTION: Heating section should never be touched as it may be hot and burns may occur.
To avoid possible scalp or hair burns, use very hot setting only when hair is wet. Reduce to lower heat as hair dries.
Do not keep appliance directed at one place; keep it in constant motion. This is especially important if drying a wig, which could be damaged by heat.
For maximum airflow, hold dryer no closer to the head than six inches. SPECIAL ATTENTION: This appliance is designed with a protective coating around the
heating coils. When operating the first few times, there may be momentary smoking when unit is switched OFF. This represents no danger to the user and does not indicate a defect in the unit. This smoke should dissipate within a short time.
To extend the life of the dryer, it is advisable to switch it to the low heat setting for a few seconds before shutting it off.
HOW TO USE THIS DRYER
This dryer features a choice of two speeds and four heat settings. Use high heats/speed for most styling/setting procedures and hair types. Select lower heats/speed for "finishing" a hairstyle or for drying and styling permed, color-treated or fragile hair.
To adjust heat and speed settings, operate switches as follows: With both speed and heat switches in the Low (I) position, slow speed and warm air. With speed switch in Low (I) and heat switch in High (II) position, slow speed and
hot air. With speed switch in High (II) and heat switch in Low (I) position, fast speed and hot air. With both speed and heat switches in the High (II) position, fast styling speed and
hottest air. TO USE THE COOL SHOT™SWITCH: The Cool Shot switch is located at the top of the
dryer handle. By simply depressing the switch, the airflow will become cool. The Cool Shot feature is used to set curls in place. Press the switch and hold it for
length of time desired. When finger is released from the switch, the dryer will automatically resume the temperature and speed previously chosen.
This appliance is permanently lubricated and will not require additional lubrication for the life of the unit. It contains no user serviceable parts. Refer service to qualified service personnel.
WHILE USING: Untwist cord from time to time to avoid tangling. TO CLEAN: Unplug unit and allow to cool. Use a soft, slightly damp cloth to wipe the
surfaces. Do not allow water or any other liquid to get into the unit. Intake grille must be cleared of any build-up of lint or hair with a small brush.
To remove grille, grasp it by notches located on rim, twist counterclockwise and pull off. To replace grille, simply twist it clockwise until it is firmly reattached to dryer housing. TO STORE: Unplug appliance, allow to cool, and store in its box or in a dry place. Never
store it while it is hot or still plugged in. Never wrap the cord tightly around the appliance. Never hang unit by the cord -- use the hanging ring provided. Do not put any stress on the cord where it enters the unit, as it could cause the cord to fray and break.
SERVICE NOTE: Before returning unit for service, please make sure the air intake grille is free of lint and hair. If it needs cleaning, clean by hand with a small brush, or use a vacuum cleaner brush attachment. If unit has a removable grille, be sure to clean the fixed grille attached to the housing as well as the removable grille. Then try to operate the unit again.
HOW TO USE
CARE AND CLEANING
Loading...
+ 4 hidden pages