
BSRT bellissimo Extension Sounder
Description
The BSRT extension sounder is designed for use with the bellissimo Video Door Entry
system, to extend the call tone to other areas of the premises for improved audibility. The
BSRT is housed in an unobtrusive white ABS enclosure for wall mounting in a convenient
indoor location. It has a control for volume adjustment during installation.
Requirements
All wiring should be carried out using Cat5 cable and where necessary a 1mm² (or greater)
power cable (see Tables).
The BSRT can be powered directly from the existing system (Option1) or from an extra
local power supply where there is insufficient power capacity available (Option 2). Use
Option 2 if there is any doubt or consult the manufacturer for further advice.
Installation & Setup
After installation press the test button of the BSRT to make it ring and then adjust the
volume pot to give a suitable ring volume for the location. The unit will sound with the
identical cadence to the videophone (continuous or intermittent) depending on the
dipswitch settings of the systemcontroller (refer to the bellissimo installation manual).
In order to operate correctly a videophone must be present and set as a Master. When
the unit is called the status LED will illuminate at the same time as the tone is sounding.
Quick Troubleshooting guide
Unit does not operate from
Test Button
Unit operates from Test
button, but not when called
Unit starts to operate and
then stops before the phone
Telephone technical:
0845 121 4008
Ensure that there is power at the connector.
Check Volume control
Ensure videophone is set to Master and operates fully
Check connections
Power-supply insufficient or excessive voltage drop
Ensure at least 10V at all times while operating.
E-mail:
technical@bellsystem.co.uk
Website:
www.bellsystem.co.uk
Made in the UK
BS EN ISO 9001:2000
Certificate number GB2000389
: This product complies with EMC directive 89/336/EEC : Generic BSEN 50081/2
PD-122 Issue 1 Installation and Operating Manual Page 1 of 2

BSRT bellissimo Extension Sounder
Option 1: Powered from videophone
System Distance L Cable
< 50m Single Cat51 BS videophone +
1 or 2 BSRT daisy chained
< 200m Cat5 +
2 x 1mm
< 50m Single Cat52 BS videophone +
1 BSRT daisy chained
< 200m Cat5 +
2 x 1mm
Option 2: Locally powered from separate PSU
2
2
System Distance L Extension from videophone
Extension <200m Cat5 – video not connected
System Distance P PSU to BSRT Cable
1 or 2 x
BSRT
< 50m 4 pairs of Cat5 or 2 x 1mm
2
PD-122 Issue 1 Installation and Operating Manual Page 2 of 2