Bellmate W150W Users Manual

W150W USER MANUAL

SPECIFICATION

1. Power source:24V/AC(18～30V).

2. Static current ≤ 13 MA/AC24V

3. Backlight current ≤ 23 MA/AC24V

4. Blue backlight

5. Backlight brightness：15——55 LUX

6. Modulation mode: ASK

7. Frequency:916MHz

8. Transmission distance: 120 meter

OPERATION

1. Connect it to power, LCD will show full display. Repeater stays in transmission mode
(this is TX testing mode). Press key once and reference number will display, it enters into
receiving mode (this is RX testing mode).

2. Press the key to select reference number (1- 4), blue back light turn on. Without further
pressing on key, the number will flash 5 seconds and stop flashing. Blue backlight will turn
on in 15 seconds without key pressing.

3. When W150W received signal from TX, symbol will flash 3 times, then red LED flash,
LCD display symbol 6 times, it means W150W has been transmitted the received data.

4. Repeat models with reference number.

Reference Number Repeat models

1 Z270W, Z260W.
2 R250W, ZDA250W, R251W, Z251W.
3 B270W, B270WH.
4 W160W

FCC ID UX2W150W

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.

NOTE:THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE
CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS
COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.

W150W INSTALLATION GUIDE

1. wall with screwFix the bottom panel on the

3. .Install the product on the bottom panel

2. Connect all wires properly.

4.Installation completion;