BO908CX
90cm Built In Oven
Installation and User manual
Content
Important Safety instructions-------------------- 1
Product description--------------------------------- 3
Installation-------------------------------------------- 4
Oven setting----------------------------------------- 6
Cooking guide----------------------------------------11
Maintenance and cleaning------------------------ 14
Warranty----------------------------------------------- 17
BO908CX
BO908CX-F
20120323 issue4
For warranty service call 1300 373 199(Australia)
or 0508 123108(New Zealand) to connect you to
the nearest authorised service centre
Important Safety Instructions 1
This manual explains the proper installation and use of your oven, please read it carefully before
using even if you are familiar with the product. The manual should be kept in a safe place for future
reference.
General Warnings
If the supply cord is damaged, the cord must be
replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a
hazard.
This product has not been designed for any uses
other than those specified in this booklet
This appliance must not be used as a space
heater.
In order to avoid fire, the appliance must be kept
clean and vents kept unobstructed.
Do not spray aerosols within the vicinity of the
appliance during operation.
Do not store flammable materials in or under the
appliance, e.g. aerosols.
Do not line the bottom of the oven with foil or
cookware.
Always use gloves when handling hot items inside
the oven.
Always turn the grill off immediately after use as
fat left behind may catch fire.
Do not leave the appliance unattended when
cooking. Oils and fats may catch fire due to
overheating or boiling over.
Do not put pans weighing over 15Kgs on the
opened door of the oven.
Do not use the appliance in the event of a
technical fault. Any faults must be fixed by an
appropriately qualified and authorised person.
In the event of any incident caused by a technical
fault, disconnect the power and report the fault to
the service centre to be repaired.
The rules and provisions contained in this
instruction manual should be strictly observed.
Do not allow anybody who is not familiar with the
contents of this instruction manual to operate the
appliance.
Child Safety
This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they’ve been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety.
Children should be supervised to ensure that they
do not play with the appliance.
During use this appliance becomes hot. Care
should be taken to avoid touching hot surfaces, e.g.
oven door, heating elements.
Accessible parts will also become hot when in use.
To avoid burns and scalds children should be kept
away.
Installation, Cleaning & Servicing
The appliance must be installed only by an
authorised person in compliance with the
instructions provided. Incorrect installation may
cause harm to persons, animals or may damage
property.
Before using the appliance, ensure that all packing
materials are removed from the appliance.
In order to avoid any potential hazard, the
enclosed installation instructions must be followed.
Ensure that all specified vents, openings and air
spaces are not blocked.
The panels adjacent to the oven must be made of
heat-resistant material.
Cabinets with a veneer exterior must be
assembled with glues which can withstand
temperature of up to 120°C.
To reduce the risk of fire, do not place or install
this unit in areas where the ventilation or
circulation ducts may become blocked. Make sure
there is at least 70mm of space between the back
of your oven and the wall. Keep some distance on
each side of your oven that you can use that
distance flowing installing instructions.
The unit's power cord must be connected to a
properly grounded and protected, 220-240V
electrical outlet. Always use ground fault
protection where required by the electrical code.
When transporting or storing the unit, keep it in a
dry location, free from dust, excessive vibration or
other factors, which may damage the unit.
Do not operate oven with a damaged cord, plug or
if the oven has malfunctioned or has been
dropped or damaged in any manner. Return
oven to authorised service facility for repair.
Only authorised personnel should carry out
servicing. (Certificate of Compliance to be
retained)
Always ensure the appliance is switched off
before cleaning or replacing parts.
Do not use steam cleaners, as this may cause
moisture build-up.
Always clean the appliance immediately after any
food spills.
THIS APPLIANCE MUST BE EARTHED.
To maintain safe operation, it is recommended
that the product be inspected every five years by
an authorised service person.
Oven
During use the appliance becomes hot. Care
should be taken to avoid touching the hot surfaces
inside the oven.
Switch the appliance off before removing the oven
light glass for globe replacement.
To avoid an accident, ensure that oven shelves
and fittings are always inserted into the appliance
in accordance with the instructions.
Do not use the door as a shelf.
Do not push down when the oven door is open.
Grill
Do not cover the grill insert with foil, as fat built up
may catch on fire.
Always keep the grill dish clean as any build up
may catch on fire.
Do not leave the grill on unattended.
To avoid fire, ensure that grill trays and fittings are
always inserted into the appliance in accordance
with the instructions.
Do not place thick portions of food under the grill.
Foods may curl, catch and ignite.
Accessible parts may become hot when grill is in
use. Children should be kept away.
Environmental Hints
Use the oven efficiently, by cooking many trays of
food at the same time.
Cook 2 trays of scones, small cakes or sausage
rolls at the same time.
Select the correct shelf location for food being
cooked.
Do not open the oven door more than necessary.
After the oven is turned off it retains heat for some
time.
This product must not be disposed together
with domestic waste. This product has to be
disposed at an authorised place for recycling
of electrical and electronic appliances.
By collecting and recycling waste, you help save natural
resources, and make sure the product is disposed in an
environmental friendly and healthy way.
2
Product Description 3
A. Control Panel
B. Function Select Knob
C. Temperature Select Knob
D. Electronic Programmable Clock (3-Keys)
E. Heating Indicator Light
F. 3 Layer Glass Door
Accessory Name Picture Quantity
Screws(ST4x25)
4
Baking Pan
1
Grill Rack 1
1
Grill Rack 2
1
Technical Data
model
product dimensions
(h x w x d) mm
electrical
connection
min. fuse
rating
max. power
rating
max. current
rating
BO908CX(-F) 475x895x548 220-240V/50Hz 15A 2.8 – 3.4Kw 14.2A
Heating elements Motor
Oven lower heating el.: 1300Watt Medium grill heating el.: 2000 Watt Fan motor 25 Watt
Oven upper heating el.: 1050Watt Total grill heating el.: 1050+2000 Watt
Oven light: 15Watt Circle heating el.: 2800Watt
Installation 4
WARNING!
Please follow the points below when
installing the appliance
Use An Authorised Person
Installation should be carried out according to the
instructions by a professionally qualified person.
The manufacturer declines all responsibility for
any damage to persons, animals or things due to
a wrong installation.
Wiring connections must be in accordance with
AS/NZS 3000 Wiring Rules and any particular
conditions of the local authority.
Refer to data plate for rating information. The
data plate is positioned behind the bottom of the
oven door. The circuit diagram is positioned on
the top panel of the appliance.
A functional switch should be provided near the
appliance in an accessible position. Refer to
AS/NZS 3000 clause 4.7.1
Wiring should be protected against mechanical
failure. Refer to AS/NZS 3000 clause 1.5
A means of disconnection with a contact
separation of at least 3mm must be supplied in
the fixed wiring. Always turn the grill off
immediately after use as fat left behind may
catch fire.
Unplug the power plug of appliance from socket
before installation or any adjustment or
maintenance.
This Appliance Must Be Properly Earthed
Do not lift the appliance by the door handles.
Prepare the cupboard opening to match your
appliance measurements. (See diagrams)
Slide appliance into the cupboard, ensuring that
the supply cable (where fitted) does not kink.
To prevent tipping, secure your oven into the
cupboard by fastening with 4 screws supplied.
Where the appliance is built into a cabinet, the
cabinet must be capable of withstanding 70°C.
Installation into low temperature tolerant
cabinetry (e.g. Vinyl coated) may result in
deterioration of the low temperature coating by
discoloring or bubbling.
The unit panels next to the appliance must be
heat resistant. In the case of veneered wood
units, glue must be resistant to a temperature of
120°C.
If the appliance is to be installed adjacent to vinyl
wrapped surfaces, use an installation kit
available from the vinyl-wrap supplier.
GSM cannot accept responsibility for damage
caused by installation into low temperature
tolerant cabinets.
After installation, test and ensure that the
appliance operates correctly before handing it
over to the customer.
Once the appliance is installed, there must be no
possible contact with electrical parts. Any
protective parts must can only be removed with
the use of tools
If a power point is fitted, it must be accessible
with the appliance installed, as the plug must be
accessible after installation
To avoid any potential hazard, you must
follow our instructions when you install
your appliance. Failure to install the
appliance correctly could invalidate any
warranty or liability claims and lead to
prosecution.
Cabinet Construction For Your Appliance
The sizes of the unit for installing the cooker under a
worktop or in a column unit are shown in figure.
To provide adequate ventilation, there must be
appropriate ventilation opening, the panel to which
the oven is fitted should have a gap of at least 70 mm
at the rear.
The unit panels next to the cooker must be heat
resistant. In the case of veneered wood units, glues
must be resistant to a temperature of 120°C.
.
Fitting Y our Appliance
Fit the appliance into its surround (beneath a work-top
or above another appliance) by inserting screws into
the 4 holes that can be seen in the frame of the oven
when the door is open.
Note:
Your applianc e must be mounted on a flat surface for
the full width and depth of the product
Connect Power Supply Cord
Pull open terminal board cover at rear panel of
appliance.
Fit wires through on terminal board and make
connections to terminals.
Engage wires into plastic clip. Secure plastic clip
with supplied screws.
Close the terminal board cover.
Plastic cli
p
Plastic clip
Securing
Mounting Screws
5
Loading...