Belkin RK5039 User Manual

RK5039 INSTRUCTIONS

RK5039 Product Inventory

1 - Power Strip Mounting Clip (3) 2 - Power Strip Mounting Bracket (3)

- 10-32 Spring Nut (3)

3 4 - 10-32 x 3/4" Pan Head Screw (3) 5 - 10-32 x 1/2" Pan Head Screw (9) 6 - 10-32 Nut with Lock Washer (6) 7 - 10-32 x 3/8" Flat Head Screw (6) 8 - 10-32 x 1/4" Pan Head Screw (9)

Your Belkin RK5039 Power Strip Mounting Kit has been designed for 19" rack mount (0) Zero U mounting. It will also mount Wiremold vertical power strips (Wiremold units using 1 1/2" narrow aluminum housing). Enough hardware has been included to mount two rack mount PDU's or one vertical power strip.

Instructions - (0) Zero U mounting

1. Install 10-32 spring nut by holding it horizontally in the slotted horizontal, pushing and turning it clockwise into a vertical position. Repeat this step three times.

2. Install power strip mounting bracket using the 10-32 x 3/4" pan head screw.

3. Install PDU using 10-32 x 1/2" pan head screw.

All trade names are registered trademarks of respective manufacturers listed.

RK5039 Instructions Page 1 P35855

19" Rack Mount (0) Zero U Mounting

.belkin.com

www

Belkin Corporation

501 West Walnut Street

Compton, CA 90220-5221, USA

Tel: 310-898-1100; Fax: 310-898-1111

Instructions - Vertical

Power Strips

. Install 10-32 spring nut by holding

it horizontally in the slotted horizontal, pushing and turning it clockwise into a vertical position. Repeat this step three times.

2. Install power strip mounting bracket using the 10-32 x 3/4" pan head screw.

3. Install power strip mounting clip using the 10-32 x 3/8" flat head screw.

4. Snap in your vertical power strip.

Vertical Power Strip Facing Sideways

Note: Power strip mounting brackets will also accept

iremold

Vertical Power Strip Facing Back

iremold "Snap-on/Slide-of

W clips (included with W power strips) used with 2" housing.