Belkin RK2000, RK2001 User Manual

RK2000 & RK2001 Instructions Page 1 P35727

RK2000 Product Inventory RK2001 Product Inventory

Vertical Upright Channel 84" (2) Vertical Upright Channel 48" (2) Base Angle (2) Base Angle (2) Top Angle (2) Top Angle (2) 1/2" - 13 x 1 Hex Bolt (12) 1/2" - 13 x 1 Hex Bolt (12) 1/2" Lock Washer (12) 1/2" Lock Washer (12) 12-24 x 1/2" lg. Screws (50) 12-24 x 1/2" lg. Screws (50)

Tools Required

3/4" Socket or Wrench Level or Carpenter Square

RK2000 and RK2001 INSTRUCTIONS

Instructions

1. Install top angles to vertical upright channels.

a. Lay vertical upright channels on edge

so tapped holes face you and the floor. Be sure open sides of upright channels face each other.

b. Align holes in top angle with

corresponding holes in vertical uprights. Formed leg of top angle should be facing toward you.

c. Install hex head bolts and lock

washers. Finger tighten only.

d. Turn vertical upright over (rotate 180

degrees) and repeat steps (a) through (c). Finger tighten only.

Top Angle

Hex Bolt and Lock Washer

RK2000 & RK2001 Instructions Page 2 P35727

www.belkin.com Belkin Corporation 501 West Walnut Street Compton, CA 90220-5221, USA Tel: 310-898-1100; Fax: 310-898-1111

Instructions (cont'd.)

2. Install base angles to vertical upright channels.

a. Leaving vertical upright channels on edge,

align holes in base with corresponding holes in each upright channel. Long leg of base should be facing you.

b. Install 4 hex head bolts and lock washers.

Finger tighten only.

c. Turn vertical upright assembly over

(rotate 180 degrees) and repeat steps (a) and (b). Finger tighten only.

3. Final tightening. a. Stand rack upright. b. Square unit using a level or carpenter square. c. Tighten all bolts using socket or wrench.

4. Secure rack to floor. All racks should be bolted to the floor, or to an equally stabilizing and secure surface, after desired location is determined.

5. Equipment installation. Your rack is now ready for installation of equipment and panels.

Base Angle