Belkin RK1003 User Manual
RK1003 INSTRUCTIONS
RK1003 Product Inventory
Wall Mount Enclosure (1)
12-24 Screw (50)
ey (4)
K
Instructions
1. Use the template on the shipping box to locate your mounting holes.
2. Your wall mount has been designed to be reversible, allowing it to swing left or right.
3. Determine left or right swing requirement before hanging your wall mount.
4. Your RK1003 is designed to use 1/4 inch hardware, 16 inch on center (wall mounting hardware not included).
When installing your RK1003 wall-mounted rack enclosure to materials such as wood, cinder block, concrete,
etc., consider the load capacity within the wall-mount structure, and be certain to check with local authorities to
determine the appropriate hardware requirements for these conditions. Because wall compositions may vary at
different installation sites, Belkin cannot warrant the fitness or suitability of any installation instructions or installation
hardware it may provide for wall-mount rack enclosures. Belkin hereby DISCLAIMS ALL WARRANTIES, EXPRESS
AND IMPLIED, INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR
PURPOSE, REGARDING THE SUFFICIENCY, FITNESS OR SUITABILITY OF ANY INSTALLATION INSTRUCTIONS OR
INSTALLATION HARDWARE BELKIN MAY PROVIDE FOR WALL-MOUNTED ENCLOSURES. Belkin recommends that
an experienced maintenance and/or technical person be consulted regarding the proper wall-mounting hardware and
procedures to be used for the anticipated load capacity of the wall-mounted rack enclosure.
.belkin.com
www
Belkin Corporation
501 West Walnut Street
Compton, CA 90220-5221, USA
Tel: 310-898-1100; Fax: 310-898-1111
2005 Belkin Corporation. All rights reserved.
©
All trade names are registered trademarks of respective manufacturers listed.
RK1003 Instructions Page 1 P35767
Loading...