Belkin F8V1027 User Manual

Table of Contents

Introduction . . . . . . . . . . . . . . . . . 2

Safety and Operation Precautions . . . 2

Getting Started . . . . . . . . . . . . . . . 3

Equipment Installation . . . . . . . . . . 3

Security Programming . . . . . . . . . . . 4

Troubleshooting . . . . . . . . . . . . . . . 5

Things You Should Know . . . . . . . . . 5

Information . . . . . . . . . . . . . . . . . 6

User Manual

F8V1027

Wireless Modem Jack

Create a phone jack for your modem from any AC outlet

Introduction

Thank you for purchasing the Wireless Modem Jack from Belkin. We are confident you will find
this an excellent solution for accessing the Internet through your TV Internet box. Please
familiarize yourself with the safety and operation information provided in this manual to ensure
your enjoyment of the full benefit of this product.

Safety and Operational Precautions

Please read and follow the precautions below when installing and using the Wireless Modem Jack:

• Read and be sure you understand all instructions.

• Follow all warnings and instructions marked on the equipment and in this manual.

• Unplug this equipment from the wall outlet before cleaning. Use a damp cloth only.
Do not use liquid or aerosol cleaners.

• Do not use this equipment near any water—including but not limited to a bathtub, washbowl,
kitchen sink, and laundry tub, in a wet basement, or in or near a swimming pool.

• Never place this equipment near or over a hot radiator or furnace register.

• This equipment should only be operated from a 120-volt, 60Hz AC power source. If you are not
sure of the type of power supplied to your home or building, consult your local power company.

• Never spill liquid on the equipment.

• To Reduce the Risk of Electric Shock:

1. Do not disassemble this equipment; take it to a qualified service facility if either service or

repair is required.

2. Do not open or remove the cover as you may be exposed to dangerous voltages or other

risks. Incorrect reassembly can cause electric shock when subsequent use of the equipment
is attempted.

3. Unplug the equipment from the wall outlet and refer servicing to a qualified service facility

under the following conditions:
a. when the AC plug is damaged
b. if liquid has been spilled into the equipment
c. if the equipment has been exposed to rain or water
d. if the equipment does not operate normally by following the operation instructions
e. if the equipment has been dropped or the cabinet has been damaged
f. if the equipment exhibits a distinct change in performance

4. Do not use a telephone during an electrical storm, except for a cordless phone. There is a

remote risk of electric shock from lightning.

5. Unplug this device, and any electrical device, during lightning storms in order to avoid

damage to the equipment.

• Do not use the telephone to report a gas leak in the area of the leak.

Important Notes on Operation

• If connecting to a surge protector, the strength of the signal may vary by outlet. Try various
outlets for the best signal strength.

• Do not plug this equipment into a UPS.

• This equipment will not operate during a power outage.

• This equipment can only be used for a single phone line.

• If you cannot get a dial tone, unplug both the base and extension unit and reset them
according to the “Troubleshooting” section of this manual.

• It is very important that you follow the installation directions in the correct order. In the event
of a problem, unplug both units, remove all cords, and start again.

2

Getting Started

Unpacking

Carefully remove units from packaging. In the
unlikely event there is any visible damage, DO
NOT attempt to operate the equipment. Notify
your dealer or shipping carrier immediately.
Keep this guide for future use.

Equipment Contents

• Base Unit

The base unit has two telephone jacks on
the right side and a green light on the
front. It plugs into the wall jack and
the phone.

• Extension Unit

The extension unit has one telephone
jack on the right side and a green
indicator light on the front. This is the
unit that can be moved from location to
location to create a phone jack in an
electrical outlet.

• Telephone Cord

A 6-foot telephone cord is provided to connect
the base unit to the existing wall phone jack.

Equipment Installation

Follow the steps below to install the Wireless Modem Jack for modem equipment.

Base Unit

NOTE: To ensure proper performance, it is important to install the base unit FIRST and then install

the extension unit. Also, ensure that both units are securely plugged into the AC wall outlet.

1. Plug either end of the provided telephone cord into either jack on the right side of the base

unit, and the other end into any existing telephone wall jack.

2. Plug the phone previously used at that location into the extra jack on the side of the

base unit.

3. Plug the base unit into an electrical outlet.

Wall Outlet

Wall Phone Jack

Telephone Cord

Base Unit

3