3
USB Installation
a. Locate the computer Universal Serial Bus (USB) port on the
back of your computer.
b. Plug your mouse into the port. Check the box in which your
mouse was shipped to verify the ports supported.
c. Sometimes, when connecting the mouse into a USB port,
Windows will detect the mouse and start the Add New
Hardware Wizard. If it does not, then go to d, bellow. If the
Wizard does come up, follow the on-screen instructions.
1) You may be prompted to insert the Windows Software
disk.
2) Insert the disk in the CD-ROM.
3) The drive and CD will come up automatically. Confirm
that it is the current drive (for example: D:\).
4) Click on OK.
5) The file needed to support the USB mouse will be
copied to your computer.
d. At this point, your mouse will work with the built-in
Microsoft
®
Operating System. To use the extra features of
your middle button, you must install the included software.
Software Installation
Hardware Installation (continued)
Windows®95 and Higher
a. Insert the Belkin AeroCruiser
™
driver software into your CD ROM
drive and then follow the instructions on your screen. If the
installation screen does not appear, complete steps b-d.
b. Click the Start button and then click Run.
c. Type <drive>:\setup.exe then press Enter. For example, if
your CD-ROM drive is D, type d:\setup.exe then press Enter
d. Follow the instructions on your screen.