CE Declaration of Conformity
We, Belkin Corporation, declare under our sole responsibility that the product F8E464, to which this
declaration relates, is in conformity with Emissions Standard EN55022 and with Immunity Standard EN55024,
LVP EN61000-3-2, and EN61000-3-3.
ICES
This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B est
conforme á la norme NMB-003 du Canada.
Belkin Corporation Limited Three-Year Product Warranty
Belkin Corporation warrants this product against defects in materials and workmanship for its warranty period.
If a defect is discovered, Belkin will, at its option, repair or replace the product at no charge provided it is
returned during the warranty period, with transportation charges prepaid, to the authorized Belkin dealer from
whom you purchased the product. Proof of purchase may be required.
THE WARRANTY AND REMEDIES SET FORTH ABOVE ARE EXCLUSIVE IN LIEU OF ALL OTHERS, WHETHER
ORAL OR WRITTEN, EXPRESSED OR IMPLIED. BELKIN SPECIFICALLY DISCLAIMS ANY AND ALL IMPLIED
WARRANTIES, INCLUDING, WITHOUT LIMITATION, WARRANTIES OF MERCHANTABILITY AND FITNESS FOR
A PARTICULAR PURPOSE.
No Belkin dealer, agent, or employee is authorized to make any modification, extension, or addition
to this warranty.
BELKIN IS NOT RESPONSIBLE FOR SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES RESULTING
FROM ANY BREACH OF WARRANTY, OR ANY OTHER LEGAL THEORY, INCLUDING BUT NOT LIMITED TO,
LOST PROFITS, DOWNTIME, GOODWILL, DAMAGE TO OR REPROGRAMMING OR REPRODUCING, ANY
PROGRAM OR DATA STORED IN OR USED WITH BELKIN PRODUCTS.
Some states do not allow the exclusion or limitation of incidental or consequential damages or exclusion of
implied warranties, so the above limitations or exclusions may not apply to you. This warranty gives you
specific legal rights, and you may also have other rights that vary from state to state.
Setup Instructions
1. Insert 4 AA batteries (included) into the battery compartment of the Battery Pack.
2. Wipe the back of your iPod to remove dust.
3. Position the Battery Pack’s two suction cups on the iPod’s back so they both make full
contact with the steel surface, with the cable exiting toward the bottom end of the iPod.
4. Connect the Battery Pack to the iPod by plugging the Battery Pack connector into the
Dock Connector of the iPod.
5. To use the Battery Pack’s batteries, slide the on/off switch to the “I” position. The iPod
now received power from the Battery Pack!
To check the remaining battery power level, press the button on the top end of the Battery
Pack. The power level from the batteries is shown by up to 4 LEDs. Once the power level
drops to one LED, it’s time to switch batteries.
When the Battery Pack is connected and turned on, the iPod will run off the battery pack, not
the internal iPod battery (as long as there is enough power in the batteries).
NOTE: The Battery Pack will not charge the iPod’s internal battery.
FCC Statement
DECLARATION OF CONFORMITY WITH FCC RULES FOR ELECTROMAGNETIC COMPATIBILITY
We, Belkin Corporation, of 501 West Walnut Street, Compton, CA 90220, declare under our sole
responsibility that the product:
F8E464
to which this declaration relates:
Complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.