Belkin F5D5730au User Manual 2

Belkin Tech Support

Australia: 1800 666 040

New Zealand: 0800 441 913

Singapore: 800 616 1790

US: 310.898.1100 ext 2263

Belkin Corporation

501 West Walnut Street

Compton • CA • 90220 • USA

Tel: [phone]
Fax: [phone]

Belkin Components, Ltd.

Express Business Park

Shipton Way • Rushden • NN10 6GL

United Kingdom
Tel: [phone]
Fax: [phone]

Belkin Components B.V.

Starparc Building • Boeing Avenue 333

1119 PH Schiphol-Rijk • The Netherlands

Tel: [phone]

Fax: [phone]

Belkin Components, Ltd.

7 Bowen Crescent • West Gosford

NSW 2250 • Australia

Tel: [phone]

Fax: [phone]

P74476au

© 2004 Belkin Corporation. All rights reserved. All trade names are

registered trademarks of respective manufacturers listed.

belkin.com

User Manual

F5D5730au

High-Speed
ADSL Modem

with USB and Ethernet

Connect your PC or network for
high-speed Internet access

TABLE OF CONTENTS

Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1

Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1

Package Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1

System Requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2

Knowing your Modem . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5

Installation Method 1 – Ethernet . . . . . . . . . . . . . . . . . . . . . . . . . 6

Installation Method 2 – USB . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6

Modem Configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7

Annex A – Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13

Annex B – FAQs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18

Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20

1

INTRODUCTION

Thank you for purchasing the Belkin High-Speed ADSL Modem with USB and
Ethernet. This Modem will allow you to surf the Web and connect to some
popular game consoles.

Features

•

RJ45 Ethernet interface support via crossover cable; USB interface support

• IEEE 802.3 standard 10/100Mbps compliance

• DHCP Server

• ANSI T1.413 Issue 2, ITU-T G.DMT (G.992.1), G.Lite (G.992.2) and

G.hs (G.994.1)

• IP Sharing via NAT routing function (Network Address Translation)

• NAT function for NetMeeting

®

, ICQ®, CU-SeeMe®, etc.

• PPPoE, PPPoA, Bridged and Routed IP (RFC 1493) Encapsulations

• Full ATM protocol support

• Multi-protocol support: IP, PPP, Transparent bridging, etc.

• Configuration, management, and firmware updates via Web

Browser Interface

• Two-level password protection for device management

• Flash memory for future firmware upgrades

• Simultaneous USB and Ethernet support

Package Contents

• Belkin High-Speed Modem with USB and Ethernet

• Power Adapter

• RJ45 Crossover Cable

• A–B USB Cable

• RJ11 Phone Cable

• CD

INTRODUCTION

2

System Requirements

PC running Windows® 98SE , Me, 2000, XP
CD-ROM drive (For USB Installation Only)
One free USB port (For USB Installation Only)
One RJ45 Ethernet port (Ethernet Installation Only)

3

KNOWING YOUR MODEM

(1)

(2)

Front of Modem

1. ADSL

ON ADSL Connected
OFF No ADSL Detected
Blinking Connecting/Han dshakin g

2. LAN

ON Ethernet Connected
OFF No Ethernet Connection
Blinking Data Transmitting

4

Back of Modem

KNOWING YOUR MODEM

Before You Start

Before you start to use your Modem you must have the following:

1. An active ADSL account and line with a user name and password.

2. IP address, DNS, and gateway settings from your ISP only if applicable.

3. At least one computer with either USB or Ethernet connection.

4. TCP/IP networking protocol installed on the computer (most computers have

this installed by default).

5. Microsoft® Internet Explorer 5.0 or Netscape® 4.5 or greater installed.

6. It may be necessary to disable any firewall or anti-virus software during

installation. It may prevent successful installation. This can be reactivated on
successful installation.

TIP: After plugging in the power cord, the Modem initialises and starts working

after 20 seconds.

TIP: If you push the Reset button, all the parameter settings will revert back to

factory default.

Ethernet

USB

Reset

RJ11

Power