Belkin F4D121 User Manual

INSTRUCTIONS

1. Lay side rails (1) on the floor.

2. Assemble base angle (2), and top angle (3) as shown in Figure 1.

3. Turn rack over and repeat base and top angles on other side.

4. Square legs. Tighten all bolts.

5. Mount to floor, using suitable fasteners (see note below).

6. Install equipment using provided screws.

NOTE:

-Due to variances in floors, shims may be needed under base angles.

-To square legs, measure diagonally

INSTRUCTION SHEET- F4D121

between top and bottom bolts. The distance between A and B should be the same as C and D (see Figure 2).

BELKIN

9/16" wrench or socket Measuring tape #2 Phillips screwdriver

FIGURE!

Parts List

ITEM QTY DESCRIPTION

1 2 Rack Leg 2 2 Rack Base 3 4 12 5 12 Hex Cap Screw 3/8-16 x 1 6 30 Pan Head Phillips 12-24 x 0.625

Top Angle

Flat Washer 3/8"