Belkin BG108000-04 User Manual
Step 1:
ComputerWireless
Router
ComputerWireless
ComputerWireless
Monitor
Printer
ComputerWireless
Monitor
Plug equipment into “Always On” outlets.
These outlets are for devices that need continuous power, such as:
• Digital video recorders • Alarm clocks
• Cordless phones • Wireless routers
Wireless routers
Cordless phones
1
Step 2:
Plug equipment into “Remote Switched” outlets.
These outlets are controlled by the remote switch and are for devices
that do not need constant power or go into standby mode, such as:
• Printers • Comp uter mo nitors
• Chargers • Televisions
• DVD players • Stereo syste ms
Quick Start Guide
2
Computers
Monitors
Conserve Energy-Saving Surge
Protector with Remote Switch
Printers
Scanners
IMPORTANT – READ BEFORE INSTALLING
© 2008 Belkin International, Inc. All rights reserved. All trade names are registered trademarks of respective manufacturers listed. PM01629 • BG108000
Step 3:
Plug Conserve power cord into the wall outlet.
Step 6:
Firmly press and release the “|” button to turn ON
the “Remote Switched” outlets.
Check to see if a green light flashes on the remote switch. This will
indicate that the remote is working.
Step 4:
Remove the remote switch and wall-mount from
the box.
Mounting screws are not included; see User Guide for
wall-mount installation.
6
I = ON
O = OFF
Step 7:
Your equipment is now powered,
surge-protected, and ready for use.
Step 8:
When finished using your equipment, turn off
each device as you normally would.
HOW TO USE THE
CONSERVE REMOTE SWITCH
Step 5:
Pull and remove the clear battery tab from the
back of the remote switch.
Remove
before usin g.
Pull
Step 9:
When your equipment is off, firmly press and
release the “O” button on the remote switch.
Check to see if a green light flashes on the remote switch. This will
indicate that you have eliminated standby power to Conserve’s
“Remote Switched” outlets. Devices plugged into the “Always On”
outlets will remain powered.
I = ON
9
O = OFF
Step 10:
When ready to use your equipment again, firmly
press and release the “|” button on the remote
switch to activate the power to the “Remote
Switched” outlets.
Step 11:
Turn on and use your equipment as normal.
Repeat Step 8 when done.
For complete instructions, see the User Guide
enclosed or visit www.belkin.com/conserve.
Loading...