Page 1
INSTRUCTIONS
Pipette Pump™lll
Catalog Number F37902 & F37904 Series
The Pipette Pump™III has a comfortable
handgrip and a thumb wheel to operate the
filling and dispensing of fluid.
Before inserting the pipette, press the
plunger all the way down.
The glass or plastic pipette is inserted into
the chuck with a slight rotating motion. The
radial fingers in the chuck’s end centralize
the pipette in the soft inner chuck.
With the pipette properly inserted, place the
end of the pipette into the liquid and roll the
thumb wheel (or pull plunger up) to draw up
the liquid. To dispense the liquid, roll the
thumb wheel in the opposite direction. The
FAST RELEASE Pipette Pump
trigger release in the handle. For quick
release dispensing, simply squeeze the trigger. Fluid will continue to be dispensed as
long as the trigger is squeezed.
If it becomes necessary to clean the Pipette
™
Pump
internally, unscrew the two metal
screws with a Philips screwdriver, then push
out the plastic pin holding the thumb wheel.
Lastly, unscrew the ribbed chuck. Be careful not to lose any of the parts. Reassemble
following steps in reverse order.
™
III includes a
Fast-Release Version Pictured
Fast Release
Trigger
For Pipettes Catalog Number
Up to 2ml F37902-0002 or F37904-0002
Up to 10ml F37902-0010 or F37904-0010
Up to 25ml F37902-0025 or F37904-0025
OTHER FINE SCIENCEWARE® PRODUCTS
FOR YOUR LABORATORY
Organize tubes, vials, plates, flasks, bottles, cells, pipettes and many other vessels
with racks from Bel-Art Products
materials to ensure long and dependable service. Most racks are steam
autoclavable at 121°C (250°F) and many are stackable to maximize storage.
Select from molded plastic, wire (coated or stainless steel) or other metals.
High capacity, wall mounted or forced-air bench top drying racks are available in
many standard configurations to safely dry labware. If your requirements are
unique, ask us to design and build a custom rack solution that can be delivered
in as few as 4 weeks. Visit the Bel-Art Products
the full selection of racks or call Customer Service at 800.423.5278 to request
a free catalog.
Contact your preferred distributor to order these and other Scienceware
®
. All racks are precision - made from high quality
®
website at www.belart.com to view
®
products.
ATTENTION GLASS PIPETTE USERS
Caution is advised when using glass pipettes with this product. Glass may break
and shatter when forced. Consult your lab safety officer for proper protocol on
glass handling.
937902100 08/04
®
, is a reg. TM of Bel-Art Products • Pipette Pump™ is a trademark of Bel-Art Products
Scienceware
Bel-Art Products assumes no obligation or liability for any advice furnished by it, or for results obtained with respect to
these products. All such advice is given and accepted at the buyer’s risk.
Find Quality Products Online at: [email protected]
www.GlobalTestSupply.com
Loading...