Beko ZA130, ZA90 Installation, Operation And Food Storage Instructions

ZA 90 ZA 130
3.6 cu.ft. Upright Freezer
BEKO plc Beko House Caxton Way Watford Hertfordshire WD18 8UF Tel: 01923 654650 Fax: 01923 819653 e-mail: service@beko.co.uk website: www.beko.co.uk
Printed in Turkey
Part no: 48 3452 00 00 Revision no: 0
1
PERFORMANCE
Energy efficiency class Energy consumption - Kwh/year Net storage - vol fresh food ltrs (cu.ft.) Net storage - vol frozen food ltrs (cu.ft) Total net vol - ltrs (cu.ft.) Frozen food compartment rating Conservation time from failure Freezing capacity fresh food - kg /24 hrs. Climate class Operating noise level dB(A)
A
204
----­85 (3.0) 85 (3.0)
4 STAR
16.5 hrs.
10.5 SN
39
Upright Freezer ZA 90 / ZA 130
Congratulations on your choice of a quality Appliance which has been designed to give you service for many years.
WARNING ! IMPORTANT !
DO NOT connect your appliance to the electricity supply until all packing and transit protectors have been removed.
• Leave to stand for at least 4 hours before switching on to allow compressor oil to settle if transported horizontally.
• If you are discarding an old refrigerator with a lock or latch fitted to the door, disable the lock/latch, ensure that it is left in a safe condition to prevent the entrapment of young children.
• This freezer must only be used for its intended purpose i.e the storing and freezing of edible foodstuff.
• Do not dispose of the appliance on a fire. At BEKO, the care and protection of our environment is an ongoing commitment. This appliance which is among the latest range introduced is particularly environment friendly. Your appliance contains non CFC / HFC natural substances in the cooling system (Called R600a) and in the insulation (Called cyclopentane) which are potentially flammable if exposed to fire. Therefore, take care not to damage, the cooling circuit / pipes of the appliance in transportation and in use. In case of a damage do not expose the appliance to fire, potential ignition source and immediately ventilate the room where the appliance is situated.
• We suggest you contact your local authority for disposal information and facilities available.
• You may install your freezer in an unheated cold room ((E.g.: garage, conservatory, annex) provided
it is protected from rain, moisture, excessive heat.
• To obtain the best possible performance and trouble free operation from your appliance it is very important to carefully read these instructions.
• On delivery, check to make sure that the product is not damaged and that all the parts and accessories are in perfect condition.
•Ensure that the plug remains readily accessible. Do not use a multiple adapter bar or extension cable.
•Failure to observe these instructions may invalidate your right to free service during the guarantee period.
WARNING- Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction. WARNING- Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer.
WARNING- Do not damage the refrigerant circuit. WARNING- Do not use electrical appliances inside the food storage compartments of the appliance,
unless they are of the type recommended by the manufacturer.
•We suggest you keep these instructions in a safe place
for easy reference.
ELECTRICAL REQUIREMENTS
Before you insert the plug into the wall socket make sure that the voltage and the frequency shown in the rating plate inside the appliance corresponds to your electricity supply. Rating label is on the left hand side of freezer inner liner. We recommend that this appliance is connected to the mains supply via a suitable switched and fused socket in a readily accessible position. Should the mains lead of the appliance become damaged or should it need replacing at any time, it must be replaced by a special purpose made mains lead which can only be obtained from a BEKO Authorised Service Agent.
WARNING! THIS APPLIANCE MUST BE EARTHED
If the fitted moulded plug is not suitable for your socket, then the plug should be cut off and an appropriate plug fitted. Destroy the old plug which is cut off as a plug with bared cord could cause a shock hazard if inserted into a socket elsewhere in the house. The moulded plug on this appliance incorporates a 13 A fuse. Should the fuse need to be replaced an ASTABEAB approved BS 1362 fuse of the same rating must be used. Do not forget to refit the fuse cover. In the event of losing the fuse cover the plug must not be used until a replacement fuse cover has been fitted. Colour of the replacement fuse cover must be the same colour as that visible on the pin face of the plug. Fuse covers are available from any good electrical store.
IMPORTANT! FITTING A DIFFERENT PLUG
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug proceed as follows: (See diagram).
1. Connect the green-yellow or
green (Earth) wire to the terminal in the plug marked 'E' or with
the symbol or coloured green and yellow or green.
2. Connect the blue (Neutral) wire
to the terminal in the plug marked 'N' or coloured black.
3. Connect the brown (Live) wire to
the terminal in the plug marked 'L' or coloured red. With alternative plugs a 13 A fuse must be fitted either in the plug or adaptor or in the main fuse box. If in doubt contact a qualified electrician.
3
FITTED WITH
BS 1362 13A FUSE ALWAYS
FIT BS 1362 REPLACEMENT
CARTRIDGE FUSE
GREEN &
YELLOW
OR
GREEN
N
BLUE
OR
BLACK
L
BROWN
OR
RED
22mm.
6mm.
6mm.
6mm.
32mm.
12mm.
FUSE
CORD GRIP
2
CONTENTS PAGE
SAFETY FIRST / ELECTRICAL REQUIREMENTS
TRANSPORTATION INSTRUCTIONS
INSTALLATION INSTRUCTIONS
REPOSITIONING THE DOOR
STARTING
TEMPERATURE CONTROL AND ADJUSTMENT
STORING FROZEN FOOD
FREEZING FRESH FOOD
DEFROSTING
CLEANING AND CARE
DO'S AND DON'TS
PROBLEM SOLVING
GUARANTEE DETAILS
HOW TO OBTAIN SERVICE
3
4
5
6-7
8
9
10
12
13
14
15
9
11
13
Loading...
+ 6 hidden pages