Beko FSP1651W User Manual

Upright Freezer FSP1651W

Congratulations on your choice of a quality Appliance which has been designed to
give you service for many years.

WARNING !
IMPORTANT !

DO NOT connect your appliance to the electricity supply until all packing and transit protectors have
been removed.

!

Leave to stand for at least 4 hours before switching on to allow compressor oil to settle if

transported horizontally.

!

If you are discarding an old refrigerator with a lock or latch fitted to the door, disable the lock/latch,

ensure that it is left in a safe condition to prevent the entrapment of children.

!

This fridge/freezer must only be used for its intended purpose i.e the storing of edible foodstuff.

!

Do not dispose of the appliance on a fire. At BEKO, the care and protection of our environment is an
ongoing commitment. This appliance which is among the latest range introduced is particularly
environment friendly. Your appliance contains non CFC / HFC natural substances in the cooling
system (Called R600a) and in the insulation (Called cyclopentane) which are potentially flammable if
exposed to fire. Therefore, take care not to damage, the cooling circuit / pipes of the appliance in
transportation and in use. In case of a damage do not expose the appliance to fire, potential ignition
source and immediately ventilate the room where the appliance is situated.

!

We suggest you contact your local authority for disposal information and facilities available.

!

To obtain the best possible performance and trouble free operation from your appliance it is very
important to carefully read these instructions.

!

On delivery, check to make sure that the product is not damaged and that all the parts and
accessories are in perfect condition.

!

Ensure that the plug remains readily accesible.

!

We do not recommend the use of extension leads and multi-way adapters.

!

Failure to observe these instructions may invalidate your right to free service during the guarantee
period.
WARNING- Do not use electrical appliances inside the food storage compartments of the appliance,
unless they are of the type recommended by the manufacturer.

WARNING- Do not use mechanical devices or other means to accelerate the defrosting process,
other than those recommended by the manufacturer.

WARNING- Do not damage the refrigerant circuit.
WARNING- Do not use electrical appliances inside the food storage compartments of the appliance,

unless they are of the type recommended by the manufacturer.

!

We suggest you keep these instructions in a safe place for easy reference.

1

Upright Freezer

FSP1651W

PERFORMANCE

Energy efficiency class

A+

Energy consumption - Kwh/year

257
Net storage – vol fresh food ltrs (cu.ft.) ­Net storage – vol frozen food ltrs (cu.ft.)

215 (7.6)

Total net vol – ltrs (cu.ft.)

215 (7.6)
Frozen food compartment rating 4 STAR
Conservation time from failure 16 hrs.
Freezing capacity fresh food – kg (lb) /24 hrs.

14 (30.8)

Climate class

SN-T

Operating noise level dB(A) 42

2

CONTENTS PAGE

SAFETY FIRST / ELECTRICAL REQUIREMENTS 3

TRANSPORTATION INSTRUCTIONS 4

INSTALLATION INSTRUCTIONS 4

GETTING TO KNOW YOUR UPRIGHT FREEZER 6

REVERSING THE DOOR 7

SUGGESTED ARRANGEMENT OF FOOD IN THE UPRIGHTFREEZER

8

TEMPERATURE CONTROL AND ADJUSTMENT 9

BEFORE OPERATING 8

STORING FROZEN FOOD 10

FREEZING FRESH FOOD 10

MAKING ICE CUBES 10

DEFROSTING 11

CLEANING AND CARE 12

DO'S AND DON'TS 13

ENERGY SAVING TIPS 14

PROBLEM SOLVING 14

GUARANTEE DETAILS 15

HOW TO OBTAIN SERVICE 16

ELECTRICAL REQUIREMENTS

Before you insert the plug into the wall socket make sure that the voltage and the frequency
shown in the rating plate inside the appliance corresponds to your electricity supply.
Rating label is on the left hand side of fridge inner liner.
We recommend that this appliance is connected to the mains supply via a suitable switched
and fused socket in a readily accessible position.
WARNING: When positioning the appliance ensure the supply cord is not trapped or
damaged.
Should the mains lead of the appliance become damaged or should it need replacing at any
time, it must be replaced by a special purpose made mains lead which can only be obtained
from a Authorised Service Agent.BEKO

WARNING! THISAPPLIANCE MUST BE EARTHED

If the fitted moulded plug is not suitable for your socket, then the plug should be cut off and
an appropriate plug fitted. Destroy the old plug which is cut off as a plug with bared cord
could cause a shock hazard if inserted into a socket elsewhere in the house.
The moulded plug on this appliance incorporates a 13 A fuse. Should the fuse need to be
replaced an ASTA approved BS 1362 fuse of the same rating must be used. Do not forget
to refit the fuse cover. In the event of losing the fuse cover the plug must not be used until a
replacement fuse cover has been fitted. Colour of the replacement fuse cover must be the
same colour as that visible on the pin face of the plug. Fuse covers are available from any
good electrical store.

WARNING: Do not locate extension sockets or charging transformers/power supplies or
Lithium-Iron battery operated products adjacent to the compressor as they could overheat.

IMPORTANT! FITTING A DIFFERENT PLUG

As the colours of the wires in the
mains lead of this appliance may
not correspond with the coloured
markings identifying the terminals
in your plug proceed as follows:
(See diagram).

1. Connect the green-yellow or
green (Earth) wire to the terminal
in the plug marked 'E' or with
the symbol or coloured
green and yellow or green.

2. Connect the blue (Neutral) wire
to the terminal in the plug
marked 'N' or coloured black.

3. Connect the brown (Live) wire to
the terminal in the plug marked 'L'
or coloured red.
With alternative plugs a 13 A fuse must be fitted either in the plug or adaptor or
in the main fuse box.
If in doubt contact a qualified electrician.

3

TRANSPORTATION INSTRUCTIONS

1.The appliance should be transported only in an upright position. The packing as supplied
must be intact during transportation.

2.If during the course of transport the appliance has to be transported horizontally, it must
only be laid on its left hand side when standing in the front of the appliance. After bringing it
to upright position,it must not be operated for at least 4 hours to allow the system to settle.

3.Failure to comply with the above instructions could result in damage to the appliance, for
which the manufacturer will not be held liable.

4.The appliance must be protected against rain, moisture and other atmospheric influences.

5. When positioning your appliance take care not to damage your flooring, pipes, wall
coverings etc. Do not move the appliance by pulling by the door or handle.

6. Empty any water in the drain tray before moving. See section „Defrosting” and „Care &
Cleaning” for further information.

7. Make sure that the defrost water pipe at the back of the product is fixed to the plastic
evaporating pan on the top of the compressor, to avoid defrost water spillage on the floor.

Important!

!

Care must be taken while cleaning/carrying the appliance not to touch the bottom of the
condenser metal wires at the back of the appliance, as this could cause injury to fingers and
hands.

!

Do not attempt to sit or stand on top of your appliance as it is not designed for such use.
You could injure yourself or damage the appliance.

!

Make sure that the mains cable is not caught under the appliance during and after moving,
as this could damage the cable.

!

Do not allow children to play with the appliance or tamper with the controls.

plc declines to accept any liability should the instructions not be followed.BEKO

This appliance has been designed to operate in ambient temperatures up to 43 degrees C
(109 degrees F). When first installed the product MUST NOT be placed in
low ambient temperatures because the freezer will not reduce to it’s standard operating
temperature. Once it has reached its steady operating state it can be re-located. So you
may then install your appliance in a garage or an unheated room without having to worry
about frozen food in the freezer being spoilt. When the ambient temperature returns to
normal, you may change the knob setting to suit your needs. If the ambient temperature is
below 0°C, the food in the fridge compartment will freeze. So, we recommend you don’t use
the fridge compartment in such low ambient conditions. You can continue using the freezer
compartment as usual.

INSTALLATION INSTRUCTIONS

1. The space in the room where the appliance is installed must not be smaller than 10 cubic

metres.

2. If the ambient temperature is below 0°C, the food in the fridge compartment will freeze.

So, we recommend you don't use the fridge compartment in such low ambient conditions.
You can continue using the freezer compartment as usual.

4