Beko DIN15210 QUICK REFERENCE GUIDE

QUICK REFERENCE GUIDE

! Attention: Please read the operating manual prior to operating the machine for the rst time.

On / Off Key

Tablet Detergent Indicator

Salt Indicator

Start / Pause / Cancel Indicator

Start / Pause / Cancel Key

Time Delay Key

Time Delay Indicator

Rinse Aid indicator

Starting your machine

Half Load Indicator

Programme Indicator

10 11

Half Load / Tablet Detergent Key

Programme Selection Key

Reset 3sec.

Reset 3 sec.

· Open the tap.

· Plug in to the socket.

· Open the door of the dishwasher.

· Place the dishes in accordance with the instructions in the

user manual.

· Make sure that the upper and lower impellers rotate freely.

· Put sufficient amount of detergent in the detergent dispenser

and close its lid.

· Make sure that indicators on programme display are illuminated by pressing On / Off key.

· Check if the Salt and Rinse Aid indicators light and add salt and / or rinse aid if needed.

Since different salt brands in the market have different

particle sizes and since the water hardness may vary, dissolution of the salt in water may take a couple of hours. Therefore, Salt Indicator remains on for a while after adding salt into the machine.

· You may use Half Load / Tablet Detergent Key and Time Delay key features as necessary.

· Refer to “Table of Programme Data and Average Consumption Values” to select a suitable programme.

Programme Table

Programme number

Programme name

Cleaning temperature

Degree of Soiling

1 Reference* 2 3 4 5

50°C 35°C70°C70°C 65°C

Most economical washing

program for the medium soiled

daily dishes that are kept waiting.

Suitable for removing the remnants on the soiled dishes that will be kept

waiting in the machine for a few

days, and thus, for preventing the

bad odor buildup.

· Select the desired programme with Programme Selection key.

· Press Start / Pause / Cancel key to start the programme.

Pay attention not to open the door of the machine when it is

running. If you need to open the door, safety system will stop your machine. There may be a rush of vapour when you open the door of your machine; be careful. The programme will resume running when you close the door.

· When the programme you have selected comes to an end, an audible warning signal with intervals of 8 seconds will warn you to turn off your machine. This audible signal will warn you 10 times before it turns off.

· Open the door of the dishwasher.

· Press On / Off key to turn off your machine.

· Indicator lights on the programme display will turn off.

· Close the tap.

· Unplug the machine from the socket.

Leave your dishes in the machine for about 15 minutes after

they are washed in order to have them cooled down. Your dishes will dry in a shorter time if you leave the door of your machine ajar during this period. This will increase the drying effectiveness of your machine.

Clean&Shine

Suitable for lightly soiled daily

dishes that are scraped or pre-

cleaned.

Daily washing program at which the

medium soiled dishes that are kept

waiting are cleaned in the fastest way.

30min.Intensive Quick&Clean

Suitable for heavily soiled dishes,

pots and pans.

Medium - Few Medium High

A=25 cm³/15 cm³ B=5 cm³

Programme sequence

The consumption values shown in the table were determined under standard conditions. Differences may therefore occur under practical conditions. * Reference programme for testing institutes The tests in accordance with EN 50242 must be carried out with a full water softener salt dispenser and a full rinse aid reservoir, and using the test programme.

Detergents

(without options)

Duration (min)

Water (I)

Energy (kWh)

A+B - A A+B A+B

Pre-wash

▼

Wash

▼

Cold rinse

▼

Hot Rinse

▼

Dry

▼

End

190 124 96 58 30

12 17,6 10,6 11,8 11,8

1,02 1,7 1,04 1,32 0,79

Pre-wash

▼

End

Wash

▼

Cold rinse

▼

Hot Rinse

▼

End

Wash

▼

Cold rinse

▼

Hot Rinse

▼

Dry

▼

End

Pre-wash

▼

Cold rinse

▼

Hot Rinse

▼

Hot Rinse

▼

Dry

▼

End

QUICK REFERENCE GUIDE

On / Off Key

When you press On / Off key, indicator lights illuminate on the display for ON position. The lights turn off in OFF position.

Visual Indicator

(If applicable)

Programme Selection Key

Refer to "Table of Programme Data and Average Consumption Values" to select a programme suitable for your dishes. Select the desired programme with programme selection key.

Half Load / Tablet Detergent Key

Half Load / Tablet Detergent Key allows you to turn on and off the Half Load and Tablet Detergent functions of your machine.

Half Load Function

If you want to run your machine without loading it completely, place your dishes into the machine as you desire. Press On / Off key to turn on your machine. Press the Half Load / Tablet Detergent key after selecting the desired programme until Half Load Indicator lights up, then press Start / Pause / Cancel key and close the door of your machine. With the Half Load option you can use every part of your lower and upper baskets and you can save from both water and power.

Rinse aid level indicator light

If this indicator light comes on, you have to

rell rinse aid (If applicable).

You can also tell whether rinse aid must be

relled by looking at the rinse aid dispenser. When the visual ll indicator is dark, there is

enough rinse aid in the dispenser.

When the colour is light, open the dispenser

and rell rinse aid.

the door of your machine. Once the time delay is over, the selected programme will start automatically.

Start / Pause / Cancel Key

When you press the Start / Pause / Cancel key, the washing programme you have selected will start.

(Start / Pause / Cancel indicator lights in Start mode, and turns off in Pause mode)

To press the Start / Pause / Cancel key, wait for two seconds

after you turn on the machine by pressing the On / Off key.

Light Indicator on oor (If applicable)

When the washing program starts, light indicator feature

activates itself automatically till the program ends. This feature is not an option, it cannot be turned off by the customer.

Canceling a programme

To cancel the program selection while the machine is operating open the door. ! Care must be taken when opening the door, as steam will escape. Press and hold Start / Pause / Cancel key for 3 seconds. Release

the key as the Start / Pause / Cancel indicator starts ashing.

Once you close the door of your machine, draining is completed in 2 minutes and the machine gives an audible warning when it is completed.

There might be residues of detergent or rinse aid left in the

machine and / or on the pieces being washed depending on the step the programme you have cancelled was in.

Tablet Detergent Function

Depending on the hardness level of the tap water, the Tablet Detergent function allows obtaining a better drying performance from the multi-purpose detergents such as 2in1, 3in1, 4in1, 5in1, etc., called as all-in-one detergents. Tablet Detergent Indicator lights when the Tablet Detergent function is selected. Salt and Rinse Aid indicators turn off when this function is activated.

Turn on your machine by pressing the On / Off key to use the Tablet Detergent function. Press the Half Load / Tablet Detergent key after selecting the desired programme until Half Load Indicator lights up, then press Start / Pause / Cancel key and close the door of your machine.

To use the Half Load and Tablet Detergent functions concurrently, turn on your machine by pressing the On / Off key and then press the Half Load / Tablet Detergent key until Half Load and Tablet Detergent Indicators illuminate together.

If you have used Half Load or Tablet Detergent features during

the last programme you used, Half Load or Tablet Detergent function will remain active in the next washing programme you will select. If you do not want to use these functions in the new programme you have selected, press the Half Load / Tablet Detergent key until the indicator of the relevant function turns off.

“Warning Sound” and "Inner Illumination” Settings (If applicable)

You can use the submenu settings to change the “Warning Sound” and “Inner Illumination” settings you will use in your machine.

To change the submenu settings:

Turn on your machine by pressing the On/Off button while pressing and holding Programme Selection and Start/Pause/Cancel keys. Firstly, P1 indicator will light up on the display. Select the desired

setting (P1, P2, P3, P4) by pressing the Programme Selection key. P1: Warning Sound (ON) - Inner illumination (ON) P2: Warning Sound (OFF) - Inner illumination (ON) P3: Warning Sound (OFF) - Inner illumination (OFF) P4: Warning Sound (ON) - Inner illumination (OFF)

Save the selected setting by pressing Start/Pause/Cancel key again.

Time Delay

Using the Time Delay key, you may delay the starting time of your programme up to 9,5 hours with increments of 30 minutes. Press Start / Pause / Cancel key after setting the Time Delay and close

15 0216 01 00_AA