CSG1675W
EN
Instruction of use
Fridge-Freezer
CSG1675W
CSG1675S
Please read these instructions first before using your appliance
Thank you for choosing a Beko appliance.
Please take some time to read this user manual before using your appliance, to ensure you
know how to safely operate the controls and functions.
Carefully follow all unpacking and installation instructions to ensure the appliance is correctly
connected and fitted prior to use.
Please write your product model and serial number on the last page of this user manual, and
store in a safe location close to the appliance for easy future reference.
This user manual may also be applicable for several other models. Differences between models
will be listed.
If you have any questions or concerns, please call our contact centre or find help and
information online at www.beko.co.uk
Recyling
This product bears the selective sorting symbol for waste electrical and electronic
equipment (WEEE).
This means that this product must be handled pursuant to European Directive 2002/96/EC
in order to be recycled or dismantled to minimize its impact on the environment.
For futher information, please contact your local or regional authorities.
Electronic products not included in the selective sorting process are potentialy dangerous
for the environment and human heath due to the presence of hazardous substances.
Congratulations on your choice of a quality Appliance which has been designed to
give you service for many years.
WARNING !
IMPORTANT !
DO NOT connect your appliance to the electricity supply until all packing and transit protectors have
been removed.
!
Leave to stand for at least 4 hours before switching on to allow compressor oil to settle if
transported horizontally.
!
If you are discarding an old refrigerator with a lock or latch fitted to the door, disable the lock/latch,
ensure that it is left in a safe condition to prevent the entrapment of children.
!
This fridge/freezer must only be used for its intended purpose i.e the storing of edible foodstuff.
!
Do not dispose of the appliance on a fire. At BEKO, the care and protection of our environment is an
ongoing commitment. This appliance which is among the latest range introduced is particularly
environment friendly. Your appliance contains non CFC / HFC natural substances in the cooling
system (Called R600a) and in the insulation (Called cyclopentane) which are potentially flammable if
exposed to fire. Therefore, take care not to damage, the cooling circuit / pipes of the appliance in
transportation and in use. In case of a damage do not expose the appliance to fire, potential ignition
source and immediately ventilate the room where the appliance is situated.
!
We suggest you contact your local authority for disposal information and facilities available.
!
To obtain the best possible performance and trouble free operation from your appliance it is very
important to carefully read these instructions.
!
On delivery, check to make sure that the product is not damaged and that all the parts and
accessories are in perfect condition.
!
Ensure that the plug remains readily accesible.
!
We do not recommend the use of extension leads and multi-way adapters.
!
Failure to observe these instructions may invalidate your right to free service during the guarantee
period.
WARNING- Do not use electrical appliances inside the food storage compartments of the appliance,
unless they are of the type recommended by the manufacturer.
WARNING- Do not use mechanical devices or other means to accelerate the defrosting process,
other than those recommended by the manufacturer.
WARNING- Do not damage the refrigerant circuit.
WARNING- Do not use electrical appliances inside the food storage compartments of the appliance,
unless they are of the type recommended by the manufacturer.
!
We suggest you keep these instructions in a safe place for easy reference.
1
Fridge-Freezer
CSG1675W; CSG1675S
PERFORMANCE
Energy efficiency class
A+
Energy consumption - Kwh/year
259
Net storage – vol fresh food ltrs (cu.ft.)
183 (6.4)
Net storage – vol frozen food ltrs (cu.ft.)
90 (3.1)
Total net vol – ltrs (cu.ft.)
298 (10.5)
Frozen food compartment rating
4 STAR
Conservation time from failure
18 hrs.
Freezing capacity fresh food – kg (lb) /24 hrs.
5 (11)
Climate class
SN-ST
Operating noise level [ dB(A) re1pW ]
42
2
CONTENTS PAGE
SAFETY FIRST / ELECTRICAL REQUIREMENTS 3
TRANSPORTATION INSTRUCTIONS 4
INSTALLATION INSTRUCTIONS 4
GETTING TO KNOW YOUR COMBI BEKO FRIDGE / FREEZER 6
REVERSING THE DOOR 7
SUGGESTED ARRANGEMENT OF FOOD IN THE FRIDGE/FREEZER 8
TEMPERATURE CONTROL AND ADJUSTMENT 9
BEFORE OPERATING 9
STORING FROZEN FOOD 10
FREEZING FRESH FOOD 10
MAKING ICE CUBES 10
DEFROSTING 11
REPLACING THE INTERIOR LIGHT BULB 11
CLEANING AND CARE 12
DO'S AND DON'TS 13
ENERGY SAVING TIPS 14
PROBLEM SOLVING 14
GUARANTEE DETAILS 15
HOW TO OBTAIN SERVICE 18
ELECTRICAL REQUIREMENTS
Before you insert the plug into the wall socket make sure that the voltage and the frequency
shown in the rating plate inside the appliance corresponds to your electricity supply.
Rating label is on the left hand side of fridge inner liner.
We recommend that this appliance is connected to the mains supply via a suitable switched
and fused socket in a readily accessible position.
WARNING: When positioning the appliance ensure the supply cord is not trapped or
damaged.
Should the mains lead of the appliance become damaged or should it need replacing at any
time, it must be replaced by a special purpose made mains lead which can only be obtained
from a BEKO Authorised Service Agent.
WARNING! THIS APPLIANCE MUST BE EARTHED
If the fitted moulded plug is not suitable for your socket, then the plug should be cut off and
an appropriate plug fitted. Destroy the old plug which is cut off as a plug with bared cord
could cause a shock hazard if inserted into a socket elsewhere in the house.
The moulded plug on this appliance incorporates a 13 A fuse. Should the fuse need to be
replaced an ASTA approved BS 1362 fuse of the same rating must be used. Do not forget
to refit the fuse cover. In the event of losing the fuse cover the plug must not be used until a
replacement fuse cover has been fitted. Colour of the replacement fuse cover must be the
same colour as that visible on the pin face of the plug. Fuse covers are available from any
good electrical store.
WARNING: Do not locate extension sockets or charging transformers/power supplies or
Lithium-Iron battery operated products adjacent to the compressor as they could overheat.
IMPORTANT! FITTING A DIFFERENT PLUG
As the colours of the wires in the
mains lead of this appliance may
not correspond with the coloured
markings identifying the terminals
in your plug proceed as follows:
(See diagram).
1. Connect the green-yellow or
green (Earth) wire to the terminal
in the plug marked 'E' or with
the symbol or coloured
green and yellow or green.
2. Connect the blue (Neutral) wire
to the terminal in the plug
marked 'N' or coloured black.
3. Connect the brown (Live) wire to
the terminal in the plug marked 'L'
or coloured red.
With alternative plugs a 13 A fuse must be fitted either in the plug or adaptor or
in the main fuse box.
If in doubt contact a qualified electrician.
3
TRANSPORTATION INSTRUCTIONS
1. The appliance should be transported only in an upright position. The packing as supplied
must be intact during transportation.
2. If during the course of transport the appliance has to be transported horizontally, it must
only be laid on its left hand side when standing in the front of the appliance. After bringing it
to upright position,it must not be operated for at least 4 hours to allow the system to settle.
3. Failure to comply with the above instructions could result in damage to the appliance, for
which the manufacturer will not be held liable.
4. The appliance must be protected against rain, moisture and other atmospheric influences.
5. When positioning your appliance take care not to damage your flooring, pipes, wall
coverings etc. Do not move the appliance by pulling by the door or handle.
6. Empty any water in the drain tray before moving. See section „Defrosting” and „Care &
Cleaning” for further information.
7. Make sure that the defrost water pipe at the back of the product is fixed to the plastic
evaporating pan on the top of the compressor, to avoid defrost water spillage on the floor.
Important!
!
Care must be taken while cleaning/carrying the appliance not to touch the bottom of the
condenser metal wires at the back of the appliance, as this could cause injury to fingers and
hands.
!
Do not attempt to sit or stand on top of your appliance as it is not designed for such use.
You could injure yourself or damage the appliance.
!
Make sure that the mains cable is not caught under the appliance during and after moving,
as this could damage the cable.
!
Do not allow children to play with the appliance or tamper with the controls.
BEKO plc declines to accept any liability should the instructions not be followed.
This appliance is equipped with “Freezer Guard” which ensures that at the advised setting
(4 - four on the control) the frozen food in the freezer will not defrost even if the ambient
temperature falls as low as -15°C. So you may then install your appliance in a garage or an
unheated room without having to worry about frozen food in the freezer being spoilt.
However at low ambient temperatures mentioned above, fridge contents are likely to freeze,
so check and consume food in the fridge accordingly. When the ambient temperature returns
to normal, you may change the setting to suit your needs.
INSTALLATION INSTRUCTIONS
1. The space in the room where the appliance is installed must not be smaller than 10 cubic
metres.
2. If the ambient temperature is below 0°C, the food in the fridge compartment will freeze.
So, we recommend you don't use the fridge compartment in such low ambient conditions.
You can continue using the freezer compartment as usual.
4
3. Do not place the appliance near cookers, radiators or in direct sunlight as this will cause
your appliance to work harder. If installed next to a source of heat or freezer, maintain
the following minimum side clearances:
From Cookers
12" (300 mm)
From Radiators
12" (300 mm)
From Refrigerators or Larder Fridge
1" (25 mm)
5
4. Make sure that sufficient room is provided
around the appliance to ensure free air
circulation.
Fit the two plastic wall spacer supplied
with the appliance rotating 1/4 turn to the
condenser on the back of the appliance
by rotating 1/4 turn. (see diagram).
5. The fridge/freezer should be located on a
smooth surface. The two front feet can be
adjusted as required. To ensure that,
your appliance is standing upright adjust
the two front feet by turning clockwise or
anti-clockwise, until the product is in
firm contact with the floor. Correct
adjustment of feet avoids excessive
vibration and noise.
6. Refer to cleaning and care section to prepare
your appliance for use.
WARNING!
Do not connect your appliance to the electricity
supply until all the packing and transit protectors
have been removed including polystyrene block(s)
inserted between the compressor motor and
the cabinet (see diagrams).
Do not remove the plastic drain tray fitted above
the compressor motor on models with
auto - defrost fridge.
COMPRESSOR
7. To take out the baskets from the freezer compartment please proceed as in item:
2
0
20
1
3
Loading...