Page 1
Warning – Adult Assembly Required!
Enclosed hardware includes sharp points and small parts
packed in plastic bags, so may present hazards to children
Dispose of plastic bags, extra hardware and any packing
material to avoid potential choking hazards.
After assembly, an adult should check hardware regularly
Trundle
Assembly Instructions
Contents:
4 maple end pieces (2 with a slot)
2 baltic birch sides
1 bottom piece
16 wood screws
4 swivel casters
A phillips screwdriver is needed for assembly.
Step 1:
With the bottom’s white side facing up, slide the slotted
maple end pieces and one of the baltic birch side pieces into
position as shown. Secure with 4 screws.
Step 2:
Place the remaining baltic birch side with it’s slot down
and in, to capture the bottom piece. Secure with 4 screws.
Step 3:
Position remaining maple end pieces so the holes in their
ends line up with the remaining holes in the sides. Turning
the partially assembled box on it’s side may make it easier
to secure the pieces with the remaining screws.
Step 4:
Turn the assembled trundle (box) upside down, so the
holes in the edge of the two slotted maple end pieces are “up”.
Press the 4 swivel casters into place in the holes provided.
Be careful to insert them fully (do not pinch your fingers
in this process!).
Turn the assembled Trundle right side up and enjoy!
prior to assembly.
to insure it is tight.
Caution: This product is not designed as a ride-on toy. It
is intended for use as a moveable storage container.
Please supervise children accordingly.
Manufactured by Beka, Inc. • 542 Selby Avenue • St. Paul, Minnesota 55102 • USA
1-888-999-2352 • www.bekainc.com • 651-222-3965 fax
Loading...