User manual
Product Name： Bluetooth Headphones
Trade Name： dyplay
Model Name：ANC 30
Series Model：ANC 40, ANC 45, ANC X, ANC Free
Manufacture's Name: Beijing Qunlitiancheng Network
Technology Co., Ltd.
Frequency:2402 – 2480 MHz
Active Noise Cancelling Bluetooth Headphones
Please read this instructions carefully and keep them
Pairing your Mobile Device
1. Press and hold the power button 2-4s until the Bluetooth indicator
blinks blue. 2. On your mobile device, turn on the Bluetooth feature.
Tip: The Bluetooth feature is usually found in the Settings menu.
3. Select your dyplay ANC 30 wireless headphones from the device list.
4. Play music on the connected mobile device.
Starting Up Automatically Reconnection
Press and hold the power button for 2-4 seconds to start the headphones
and the
device. If you
headphones will automatically reconnect a recently connected
want to connect another device, press and hold the power
button to disconnect the first device.
Function Key Introduction
Volume Up
(Skip Forward-Press and hold)
ANC indicator
NC
Power/Bluetooth button
Incoming call:
Answer-Press once
Decline-Press and hold
While on a call:
End-Press once
Music:
Play/Pause-Press once
Volume Down
(Skip Backward-Press and hold)
Hands-free calling with
vibration notification
Battery and Bluetooth indicator
Active Noise Cancelling
USB connector
PS:1.It is not allowed to be used when charging, and the power will be off automatically when charging. Depend
the function of the phone, there may be differences in the way of operating.
2.The noise cancelling function can be used even the headphones is turned off. The noise cancelling function
is powered by the battery in the headphones. So it is suggested to turn off the noise cancelling function to
avoid the power loss when the noise reduction function is not used.
on
FCC Caution.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used
in portable exposure condition without restriction.
Loading...